LNBP12SP STMicroelectronics, LNBP12SP Datasheet - Page 2

• Manufacturer Part Number: LNBP12SP
• Description: LNB SUPPLY AND CONTROL VOLTAGE REGULATOR PARALLEL INTERFACE
• Manufacturer: STMicroelectronics

LNBP10 SERIES - LNBP20
2/18
accomplished thanks to the fast response of the
ENT input and the prompt oscillator start-up. This
helps designers who want to implement the
DiSEqC
In order to improve design flexibility and to allow
implementation of newcoming LNB remote
control standards, an analogic modulation input
pin is available (EXTM). An appropriate DC
blocking capacitor must be used to couple the
modulating signal source to the EXTM pin. When
external modulation is not used, the relevant pin
can be left open.
Two pins are dedicated to the overcurrent
protection/monitoring: CEXT and OLF. The
overcurrent protection circuit works dynamically:
as soon as an overload is detected in either LNB
output, the output is shut-down for a time Toff
determined by the capacitor connected between
CEXT and GND. Simultaneously the OLF pin,
that is an open collector diagnostic output flag,
(*): External components are needed to comply to level 2.x and above (bidirectional) DiSEqC
a trademark of EUTELSAT.
ORDERING NUMBERS
PIN CONFIGURATIONS
LNBP10
LNBP11
LNBP12
LNBP13
LNBP14
LNBP15
LNBP16
LNBP20
Type
protocols (*).
Multiwatt-15
LNBP20CR
Multiwatt-15
PowerSO-20
LNBP20PD
from HIGH IMPEDANCE state goes LOW. After
the time has elapsed, the output is resumed for a
time t
IMPEDANCE. If the overload is still present, the
protection circuit will cycle again through t
t
value is 1200ms when a 4.7 F external capacitor
is used.
This dynamic operation can greatly reduce the
power dissipation in short circuit condition, still
ensuring excellent power-on start up even with
highly capacitive loads on LNB outputs.
The device is packaged in Multiwatt15 for
thru-holes mounting and in PowerSO-20 for
surface mounting. When a limited functionality in
a smaller package matches design needs, a
range of cost-effective PowerSO-10 solutions is
also offered. All versions have built-in thermal
protection against overheatingdamage.
on
until the overload is removed. Typical t
PowerSO-20
on
=1/15t
off
bus hardware requirements. DiSEqC
(typ.) and OLF goes in HIGH
LNBP10SP
LNBP11SP
LNBP12SP
LNBP13SP
LNBP14SP
LNBP15SP
LNBP16SP
PowerSO-10
PowerSO-10
off
on
+t
and
is
off