PQ015EZ01 Sharp, PQ015EZ01 Datasheet - Page 18

• Manufacturer Part Number: PQ015EZ01
• Description: DEVICE SPECIFICATION FOR VOLTAGE REGULATOR
• Manufacturer: Sharp

SHARP CORPORATION
7.4 Soldering
7.3 Static electricity
240.X
200°C
180°C
(cl Use a solder dip basin with a minimum
(1) Reflow soldering
consists
(b) Anything
25X,
Good caution
against
(al frytibody
Also the solder dip basin must be grounded.
and the time within
(The temperature
It is recommended
room temperature.
(a) An infrared
(bl The temperature
resistance
It is recommended
inserter,
<
localized
resin portion
excessive voltages
of a bipolar
.
or measuring
that is in contact with the device such as workbench,
must be exercised
10MQ or more] from the commercial
temperature
must be grounded
2 min
lamp used to heat up for soldering
IC. Following
should
shown in the figure is fin portion
that within
that the second reflow become at the device which is the
the temperature
sloping when soldering-reflow
such as caused by static electricity.
instrument
be with in the temperature
rise in the resin.
against
two times soldering
are some examples
>
to discharge
<
must be grounded.
profile as shown in the figure.
static electricity
<
leak current
1 min ’
The temperature
80s
the static electricity
power supply.
be done at the temperature
may cause a
of preventive
temperature
is 4E/s or less.
proffle below.
(isolation
since this device
‘i
!+-iGiPd
of
of the device.)
measures
from the body