ICX205 SONY [Sony Corporation], ICX205 Datasheet

no-image

ICX205

Manufacturer Part Number
ICX205
Description
Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras
Manufacturer
SONY [Sony Corporation]
Datasheet
Description
interline CCD solid-state image sensor with a square
pixel array and 1.45M effective pixels. Progressive
scan allows all pixels' signals to be output
independently within approximately 1/7.5 second.
Also, the adoption of high frame rate readout mode
supports 30 frames per second. This chip features
an electronic shutter with variable charge-storage
time which makes it possible to realize full-frame still
image without a mechanical shutter. High sensitivity
and low dark current are achieved through the
adoption of HAD (Hole-Accumulation Diode) sensors.
electronic still cameras, PC input cameras, etc.
Features
• Progressive scan allows individual readout of the
• High horizontal and vertical resolution (both approx.
• Supports high frame rate readout mode
• Square pixel
• Horizontal drive frequency: 14.318MHz
• No voltage adjustments
• High resolution, high sensitivity, low dark current
• Low smear, excellent antiblooming characteristics
• Continuous variable-speed shutter
Device Structure
• Interline CCD image sensor
• Image size:
• Total number of pixels:
• Number of effective pixels:
• Number of active pixels:
• Chip size:
• Unit cell size:
• Optical black:
• Number of dummy bits:
• Substrate material:
The ICX205AL is a diagonal 8mm (Type 1/2)
This chip is suitable for applications such as
image signals from all pixels.
1024TV-lines) still image without a mechanical shutter.
(effective 256 lines output, 30 frame/s)
(reset gate and substrate bias are not adjusted.)
Sony reserves the right to change products and specifications without prior notice. This information does not convey any license by
any implication or otherwise under any patents or other right. Application circuits shown, if any, are typical examples illustrating the
operation of the devices. Sony cannot assume responsibility for any problems arising out of the use of these circuits.
Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras
Diagonal 8mm (Type 1/2)
1434 (H)
1392 (H)
1360 (H)
7.60mm (H)
4.65µm (H)
Horizontal (H) direction: Front 2 pixels, rear 40 pixels
Vertical (V) direction:
Horizontal 20
Vertical 3
Silicon
1050 (V) approx. 1.50M pixels
1040 (V) approx. 1.45M pixels
1024 (V) approx. 1.40M pixels (7.959mm diagonal)
4.65µm (V)
6.20mm (V)
– 1 –
Front 8 pixels, rear 2 pixels
ICX205AL
2
20 pin DIP (Cer-DIP)
V
Optical black position
Pin 11
(Top View)
H
Pin 1
40
E98619A99
8
2

Related parts for ICX205

ICX205 Summary of contents

Page 1

... Diagonal 8mm (Type 1/2) Progressive Scan CCD Image Sensor with Square Pixel for B/W Cameras Description The ICX205AL is a diagonal 8mm (Type 1/2) interline CCD solid-state image sensor with a square pixel array and 1.45M effective pixels. Progressive scan allows all pixels' signals to be output independently within approximately 1/7 ...

Page 2

... Note) Note) : Photo sensor 19 20 Symbol Description V Supply voltage DD GND GND SUB Substrate clock Substrate bias SUB NC V Protective transistor bias L RG Reset gate clock H Horizontal register transfer clock 1 H Horizontal register transfer clock 2 ICX205AL ...

Page 3

... Item – GND SUB , V – GND GND – – 3 – ICX205AL Ratings Unit Remarks –40 to +10 V –50 to +15 V –50 to +0.3 V –40 to +0.3 V – –0.3 to +18 V –10 to +18 V – ...

Page 4

... Unit Remarks mA Waveform Unit Remarks diagram VH02A VL1 High-level coupling V 2 High-level coupling V 2 Low-level coupling V 2 Low-level coupling Low-level coupling V 4 Low-level coupling V 5 ICX205AL )/2 VL3 ...

Page 5

... V2A C V2A3 C V13 Horizontal transfer clock equivalent circuit C RG – 5 – Typ. Min. Max. Unit pF 2200 pF 1800 pF 6800 pF 3300 pF 1200 pF 1200 pF 2200 100 680 Ω 36 Ω 56 Ω 43 Ω 30 Ω 15 Ω ICX205AL Remarks H 2 ...

Page 6

... VHL V VLH VLL VH02A + V )/2 VL01 VL03 VL03 – 6 – and – VH1 VL01 – V V2A VH02A VL2A – V V2B VH02B VL2B – VH3 VL03 ICX205AL ...

Page 7

... V RG Point A is the minimum value of the coupling waveform during the period from RGLL and V . RGLH RGLL . RGLm 100% 90% V SUB 10 twh – 7 – twl V and H waveforms and H is two twl ICX205AL RGL ...

Page 8

... CR 1 two Unit Remarks Min. Typ. Max 600 700 Wave Length [nm] – 8 – Unit 0.5 0.5 µs During readout 15 450 0.01 0.01 µs 0.01 0. During drain 0.5 0.5 µs charge and H waveforms must 800 900 1000 ICX205AL Remarks 1 2 ...

Page 9

... Zone Zone II, II' Ignored region Effective pixel region C.D.S AMP S/H – 9 – Measurement Unit Remarks method mV 1 1/30s accumulation 60° electronic shutter % 4 Zone 0 and Zone 60° 60° Signal output [ B] ICX205AL (Ta = 25°C) ...

Page 10

... All effective areas are scanned in approximately 1/30s by reading out two out of eight lines (1st and 4th lines, 9th and 12th lines). The vertical resolution is approximately 256TV-lines. This readout mode emphasizes processing speed over vertical resolution. High frame rate readout mode OUT – 10 – ICX205AL ...

Page 11

... Measure the average value of the signal output (Vdt [mV]) with the device ambient temperature 60°C and the device in the light-obstructed state, using the horizontal idle transfer level as a reference color temperature of 3200K halogen source subject the center of the screen, and substitute the value into the S 100 [%] (1/10V method conversion value) – 11 – ICX205AL ...

Page 12

... Adjust the signal output value generated by strobe light to 150mV. After setting the strobe light so that it strobes with the following timing, measure the residual signal (Vlag). Substitute the value into the following formula. Lag = (Vlag/150) 100 [%] VD V2A Strobe light timing Output Light Signal output 150mV Vlag (Lag) – 12 – ICX205AL ...

Page 13

... ICX205AL ...

Page 14

... ICX205AL ...

Page 15

... ICX205AL ...

Page 16

... ICX205AL ...

Page 17

... ICX205AL ...

Page 18

... ICX205AL ...

Page 19

... ICX205AL ...

Page 20

... Upper ceramic Low melting Lower ceramic point glass Compressive strength 29N Shearing strength Tensile strength – 20 – ICX205AL 29N 0.9Nm Torsional strength ...

Page 21

... Do not expose to strong light (sun rays) for long periods. For continuous using under cruel condition exceeding the normal using condition, consult our company. b) Exposure to high temperature or humidity will affect the characteristics. Accordingly avoid storage or usage in such conditions. – 21 – ICX205AL ...

Page 22

... ICX205AL ...

Related keywords