K9F2808Q0C-HCB0 SAMSUNG [Samsung semiconductor], K9F2808Q0C-HCB0 Datasheet - Page 27

• Manufacturer Part Number: K9F2808Q0C-HCB0
• Description: 16M x 8 Bit NAND Flash Memory
• Manufacturer: SAMSUNG [Samsung semiconductor]

K9F2808U0C
Figure 10. Program Operation
PAGE PROGRAM
The device is programmed basically on a page basis, but it does allow multiple partial page programing of a byte/word or consecutive
bytes/words up to 528, in a single page program cycle. The number of consecutive partial page programming operation within the
same page without an intervening erase operation should not exceed 2 for main array and 3 for spare array. The addressing may be
done in any random order in a block. A page program cycle consists of a serial data loading period in which up to 528 bytes of data
may be loaded into the page register, followed by a non-volatile programming period where the loaded data is programmed into the
appropriate cell. About the pointer operation, please refer to the attached technical notes.
The serial data loading period begins by inputting the Serial Data Input command(80h), followed by the three cycle address input and
then serial data loading. The words other than those to be programmed do not need to be loaded.The Page Program confirm com-
mand(10h) initiates the programming process. Writing 10h alone without previously entering the serial data will not initiate the pro-
gramming process. The internal write controller automatically executes the algorithms and timings necessary for program and verify,
thereby freeing the system controller for other tasks. Once the program process starts, the Read Status Register command may be
entered, with RE and CE low, to read the status register. The system controller can detect the completion of a program cycle by mon-
itoring the R/B output, or the Status bit(I/O 6) of the Status Register. Only the Read Status command and Reset command are valid
while programming is in progress. When the Page Program is complete, the Write Status Bit(I/O 0) may be checked(Figure 10). The
internal write verify detects only errors for "1"s that are not successfully programmed to "0"s. The command register remains in Read
Status command mode until another valid command is written to the command register.
R/B
I/Ox
80h
Address & Data Input
10h
27
t
PROG
70h
FLASH MEMORY
I/O
Fail
0
Pass