ADS-118MM-C Murata, ADS-118MM-C Datasheet - Page 6

no-image

ADS-118MM-C

Manufacturer Part Number
ADS-118MM-C
Description
buffers. 1v input range, no pipeline delay, -55 c to +125 c temperature range, rohs compliant....
Manufacturer
Murata
Datasheet
DATEL
THERMAL REQUIREMENTS
All DATEL sampling A/D converters are fully characterized and specifi ed
over operating temperature (case) ranges of
0 to +70°C and –55 to +125°C. All room temperature
(T
sinks or forced air cooling. Thermal impedance fi gures for each device
are listed in their respective specifi cation tables.
These devices do not normally require heat sinks, however, standard
precautionary design and layout procedures should be used to ensure
devices do not overheat. The ground and power planes beneath the
package, as well as all pcb signal runs to and from the device, should be
as heavy as possible to help conduct heat away from the package.
A
= +25°C) production testing is performed without the use of heat
–100
–110
–120
–130
–10
–20
–30
–40
–50
–60
–70
–80
–90
®
0
0
kHz
250
(fs = 5MHz, fin = 2.45MHz, Vin = –0.5dB, 4,096-point FFT)
500
kHz
Figure 5. FFT Analysis of ADS-118
kHz
750
MHz
1
Frequency
MHz
1.25
®
• 11 Cabot Boulevard, Mansfi eld, MA 02048-1151 USA • Tel: (508) 339-3000 • www.datel.com • e-mail: help@datel.com
MHz
1.5
MHz
1.75
MHz
2
MHz
2.25
MHz
Electrically-insulating, thermally-conductive "pads" may be installed
underneath the package. Devices should be soldered to boards rather than
socketed, and of course, minimal air fl ow over the surface can greatly help
reduce the package temperature.
In more severe ambient conditions, the package/junction temperature of a
given device can be reduced dramatically (typically 35%) by using one of
DATEL's HS Series heat sinks. See Ordering Information for the assigned
part number. See page 1-183 of the DATEL Data Acquisition Components
Catalog for more information on the HS Series. Request DATEL Application
Note AN8, "Heat Sinks for DIP Data Converters",
or contact DATEL directly, for additional information.
2.5
12-Bit, 5MHz, Low-Power Sampling A/D Converters
0
Figure 6. ADS-118 Histogram and Differential Nonlinearity
+0.67
–0.47
ADS-118, ADS-118A
0
0
Digital Output Code
Digital Output Code
31 Mar 2011 ADS-118.B03 Page 6 of 8
4096
4096

Related parts for ADS-118MM-C