FT232HL-TRAY FTDI, FT232HL-TRAY Datasheet - Page 41

• Manufacturer Part Number: FT232HL-TRAY
• Description: usb-to-uart 1-ch 1.8v/3.3v 48-pin lqfp tray...
• Manufacturer: FTDI

4.10 CPU-style FIFO Interface Mode Description
CPU-style FIFO interface mode is designed to allow a CPU to interface to USB via the FT232H. This mode
is enabled in the external EEPROM. The interface is achieved using a chip select bit (CS#) and address bit
(A0). When the FT232H is in CPU-style Interface mode, the IO signal lines are configured as given in
Table 4.6. This mode uses a combination of CS# and A0 to determine the operation to be carried out.
The following Truth-Table 4.7 gives the decode values for particular operations.
CS#
1
0
0
Table 4.6 CPU-Style FIFO Interface Operation Select
The Status read is shown in Table 4.7
Data Bit
bit 0
bit 1
bit 2
bit 3
bit 4
bit 5
bit 6
bit 7
Table 4.7 CPU-Style FIFO Interface Operation Read Status Description
Note that bits 7 to 4 can be arbitrary values and that X= not used.
The timing of reading and writing in this mode is shown in Figure 4.21 and Table 4.8.
Figure 4.21 CPU-Style FIFO Interface Operation Signal Waveforms.
Copyright © 2011 Future Technology Devices International Limited
A0
X
0
1
Data
1
1
1
1
X
X
X
X
FT232H SINGLE CHANNEL HI-SPEED USB TO MULTIPURPOSE UART/FIFO IC
RD#
X
Read Data Pipe
Read Status
Status
Data available (=RXF)
Space available (=TXE)
Suspend
Configured
X
X
X
X
Document No.: FT_000288
Clearance No.: FTDI #199
WR#
X
Write Data Pipe
Send Immediate
Datasheet Version 1.6
41