MAX1464CAI+T Maxim Integrated, MAX1464CAI+T Datasheet - Page 26
![no-image](/images/no-image-200.jpg)
MAX1464CAI+T
Manufacturer Part Number
MAX1464CAI+T
Description
Digital Signal Processors & Controllers - DSP, DSC Low-Power Low-Noise Multichannel Sensor Signal Processor
Manufacturer
Maxim Integrated
Series
MAX1464r
Datasheet
1.MAX1464CAIT.pdf
(47 pages)
Specifications of MAX1464CAI+T
Data Bus Width
16 bit
Program Memory Size
4 KB, 128 B
Maximum Clock Frequency
5.3 MHz
Number Of Programmable I/os
2
Operating Supply Voltage
5 V
Interface Type
SPI
On-chip Adc
Yes
Processor Series
MAX1464
Product
DSPs
Program Memory Type
Flash
Low-Power, Low-Noise Multichannel
Sensor Signal Processor
CPU Cycles required:
Description:
Perform a 16-bit move operation from port-X to the A-
register.
The port-X contents are unchanged.
The previous contents of A-register are overwritten
and lost.
The port-X can be any of the CPU ports.
PC is incremented once to point to the next instruction
in program memory.
Two’s-complement data format is preserved.
No branching occurs.
No other registers are affected.
WRX
Op-code:
Operation:
CPU Cycles required:
Description:
Perform a 16-bit move operation from the A-register to
port-X.
The A-register contents are unchanged.
The previous contents of port-X are overwritten
and lost.
The port-X can be any of the CPU ports.
PC is incremented once to point to the next instruction
in program memory.
Two’s-complement data format is preserved.
No branching occurs.
No other registers are affected.
26
______________________________________________________________________________________
1 cycle
Port-X ← A-register
PC-register ← PC + 1 (point to next instruction)
1 cycle
Write Port X
1110 XXXX
BINARY
EXh
MLT
Op-code:
Operation:
CPU Cycles required:
Description:
Perform a 16-bit by 16-bit arithmetic multiplication of
the M-register and the N-register producing a 32-bit
result. The 32-bit result is stored in two 16-bit registers;
the A-register receives the most significant word of the
result and the M-register receives the least significant
word of the result.
The A-register must be cleared to zero (CLX A) before
executing the MLT instruction. The previous contents of
the A-register are overwritten and lost.
The previous contents of the M-register are overwritten
and lost.
The contents of the N-register are not altered.
The register op code must be 3h.
PC is incremented once to point to the next instruction
in program memory.
Two’s-complement data format is preserved.
No branching occurs.
No other registers are affected.
Multiply
A-register | M-register ← N-register x M-register
PC-register ← PC + 1 (point to next instruction)
16 cycles
1111 0011
BINARY
F3h