M24C16-RMC6TG STMicroelectronics, M24C16-RMC6TG Datasheet - Page 8

• Manufacturer Part Number: M24C16-RMC6TG
• Description: EEPROM 16Kbit 100kHz I2C 400 kHZ Fast-Mode
• Manufacturer: STMicroelectronics

Specifications of M24C16-RMC6TG

• Product Category: EEPROM
• Rohs: yes

Signal description
2
2.1
2.2
2.3
2.4
2.5
2.5.1
2.5.2
8/36
Signal description
Serial Clock (SCL)
The signal applied on the SCL input is used to strobe the data available on SDA(in) and to
output the data on SDA(out).
Serial Data (SDA)
SDA is an input/output used to transfer data in or data out of the device. SDA(out) is an
open drain output that may be wire-OR’ed with other open drain or open collector signals on
the bus. A pull-up resistor must be connected from Serial Data (SDA) to V
indicates how to calculate the value of the pull-up resistor).
Write Control (WC)
This input signal is useful for protecting the entire contents of the memory from inadvertent
write operations. Write operations are disabled to the entire memory array when Write
Control (WC) is driven high. Write operations are enabled when Write Control (WC) is either
driven low or left floating.
When Write Control (WC) is driven high, device select and address bytes are
acknowledged, Data bytes are not acknowledged.
V
V
Supply voltage (V
Operating supply voltage V
Prior to selecting the memory and issuing instructions to it, a valid and stable V
within the specified [V
in
recommended to decouple the V
10 nF to 100 nF) close to the V
This voltage must remain stable and valid until the end of the transmission of the instruction
and, for a write instruction, until the completion of the internal write cycle (t
Power-up conditions
The V
(see Operating conditions in
vary faster than 1 V/µs.
SS
SS
Section 8: DC and AC
is the reference for the V
CC
(ground)
voltage has to rise continuously from 0 V up to the minimum V
CC
(min), V
parameters). In order to secure a stable DC supply voltage, it is
CC
Section 8: DC and AC parameters)
CC
)
DocID023494 Rev 2
CC
CC
supply voltage.
CC
/V
CC
(max)] range must be applied (see Operating conditions
SS
line with a suitable capacitor (usually of the order of
package pins.
M24C16-W M24C16-R M24C16-F
and the rise time must not
CC
operating voltage
CC
W
).
(Figure 12
CC
voltage