LC75852E-E ON Semiconductor, LC75852E-E Datasheet - Page 10

• Manufacturer Part Number: LC75852E-E
• Description: LCD Drivers LCD DISPLAY DRIVER
• Manufacturer: ON Semiconductor

Specifications of LC75852E-E

• Rohs: yes
• Operating Supply Voltage: 4.5 V to 6 V
• Maximum Operating Temperature: + 85 C
• Minimum Operating Temperature: - 40 C
• Package / Case: QIP-64E
• Maximum Power Dissipation: 200 mW

3. Key Scan during Sleep Mode
Multiple Key Presses
Without the insertion of additional diodes, the LC75852 supports key scan for double key presses in general, triple key
presses of keys on the lines for input pins KI1 to KI5, and multiple key presses of keys on the lines for the output pins
KS1 to KS6. However, if multiple key presses in excess of these limits occur, the LC75852 may recognize keys that
were not pressed as having been pressed. Therefore, series diodes must be connected to each key.
• The pins KS1 to KS6 are set high or low according to the S0 and S1 control data bits.
• If a key for a line corresponding to one of the pins KS1 to KS6 which is high is pressed, the oscillator at the OSC
• When a key has been pressed for 800T [s] (where T = 1/f
• After the controller has finished reading the key data, the LSI clears the key data read request (by setting DO high)
• Key scan example in sleep mode
(See the description of the control data function for details.)
pin starts and a key scan is performed. The key scan continues until all keys have been released. Multiple key
presses can be recognized by determining if multiple key data bits have been set.
is output to the controller. The controller acknowledges this request and reads the key data. However, DO will go
high when CE is high during a serial data transfer.
and performs another key scan. Note that since DO is an open drain output, a pull-up resistor of between 1 and 10 kΩ
is required.
Example: Here S0 = 0 and S1 = 1 (This is a sleep in which only KS6 is high.)
LC75852E, 75852W
OSC
) or longer, a key data read request (DO is set to low)
No. 4828-10/16