AT89LP828-AU Atmel, AT89LP828-AU Datasheet - Page 37

• Manufacturer Part Number: AT89LP828-AU
• Description: 8-bit Microcontrollers - MCU Single-Cycle 8051 8K ISP Flash, 2.4-5.5V
• Manufacturer: Atmel

Specifications of AT89LP828-AU

• Product Category: 8-bit Microcontrollers - MCU
• Rohs: yes
• Core: 8051
• Data Bus Width: 8 bit

10.1.2
10.1.3
3654A–MICRO–8/09
Input-only Mode
Open-drain Output
The input only port configuration is shown in
input includes a Schmitt-triggered input for improved input noise rejection. The input circuitry of
P3.2, P3.3, P3.6, P4.0 and P4.1 is not disabled during Power-down (see
fore these pins should not be left floating during Power-down when configured in this mode.
Figure 10-2. Input Only
Figure 10-3. Input Circuit for P3.2, P3.3 and P3.6
The open-drain output configuration turns off all pull-ups and only drives the pull-down transistor
of the port pin when the port latch contains a logic “0”. To be used as a logic output, a port con-
figured in this manner must have an external pull-up, typically a resistor tied to V
down for this mode is the same as for the quasi-bidirectional mode. The open-drain port configu-
ration is shown in
Power-down (see
down when configured in this mode.
Figure 10-4. Open-drain Output
From Port
Register
Figure
Figure
Input
Data
Input
Data
10-3) and therefore these pins should not be left floating during Power-
10-4. The input circuitry of P3.2, P3.3 and P3.6 is not disabled during
PWD
Input
Data
Figure
PWD
10-2. The output drivers are tristated. The
AT89LP428/828
Port
Pin
Port
Pin
Figure
Port
Pin
10-3) and there-
CC
. The pull-
37