AT88SC0808CA-MJ Atmel, AT88SC0808CA-MJ Datasheet - Page 27
![no-image](/images/manufacturer_photos/0/0/78/atmel_sml.jpg)
AT88SC0808CA-MJ
Manufacturer Part Number
AT88SC0808CA-MJ
Description
IC EEPROM 8KBIT 4MHZ M2J
Manufacturer
Atmel
Series
CryptoMemory®r
Specifications of AT88SC0808CA-MJ
Format - Memory
EEPROMs - Serial
Memory Type
EEPROM
Memory Size
8K (1K x 8)
Speed
4MHz
Interface
I²C, 2-Wire Serial
Voltage - Supply
2.7 V ~ 3.6 V
Operating Temperature
0°C ~ 70°C
Package / Case
M2 J, Smart Card Module
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
8.
8.1.
26
Synchronous Protocol
Communication with Atmel
Atmel AT24Cxxx Serial EEPROM devices using a two-wire protocol (TWI). Basic command structure and timing are the
same however a significant difference exists when reading the CryptoMemory device that will be described below.
Start-up Sequence
When first powering up the device, five pulses are required on CLK-SCL for reading of internal registers. This may be
accomplished by sending one full command byte to the device. The device will not respond but will then be ready to
respond to the next correct command sequence.
• Power-up V
• External pull-up resistor pulls I/O-SDA high with V
• After stable V
• CLK-SCL and I/O-SDA may be driven.
Figure 11. Start-up Sequence
CLK-SCL
Atmel AT88SC0104/0204/0404/0808/CA
I/O-SDA
V cc
CC
CC
, 5 pulses are applied to CLK-SCL
®
CryptoMemory
1
2
3
®
using the synchronous protocol is very similar to communication with
4
CC
5
8664C–CRYPT–01/10