TWR-12311-EU Freescale Semiconductor, TWR-12311-EU Datasheet - Page 8

• Manufacturer Part Number: TWR-12311-EU
• Description: Development Boards & Kits - Other Processors Tower Mod for Europe
• Manufacturer: Freescale Semiconductor

Specifications of TWR-12311-EU

• Rohs: yes
• Product: Development Systems
• Tool Is For Evaluation Of: MC12311
• Core: HCS08
• Interface Type: SPI, USB
• Operating Supply Voltage: 3.5 V to 10 V
• Data Bus Width: 8 bit
• For Use With: MC12311

Safety Information
radiators that must be professionally installed, such as perimeter protection systems and some field
disturbance sensors, or to other intentional radiators which, in accordance with Section 15.31(d), must be
measured at the installation site. However, the installer shall be responsible for ensuring that the proper
antenna is employed so that the limits in this Part are not exceeded.
1.2
This device complies with Industry Canada licence-exempt RSS standard(s). Operation is subject to the
following two conditions:
1.2.1
Le présent appareil est conforme aux CNR d'Industrie Canada applicables aux appareils radio exempts de
licence. L'exploitation est autorisée aux deux conditions suivantes:
1.3
Although damage from electrostatic discharge (ESD) is much less common on these devices than on early
CMOS circuits, normal handling precautions should be used to avoid exposure to static discharge.
Qualification tests are performed to ensure that these devices can withstand exposure to reasonable levels
of static without suffering any permanent damage.
All ESD testing is in conformity with the JESD22 Stress Test Qualification for Commercial Grade
Integrated Circuits. During the device qualification ESD stresses were performed for the human body
model (HBM), the machine model (MM) and the charge device model (CDM).
All latch-up test testing is in conformity with the JESD78 IC Latch-Up Test.
When operating or handling the development boards or components, Freescale strongly recommends
using at least the grounding wrist straps plus any or all of the following ESD dissipation methods:
1.4
This product may be subject to special disposal requirements. For product disposal instructions, refer to
www.freescale.com/productdisposal.
1-2
1. This device may not cause interference, and
2. This device must accept any interference, including interference that may cause undesired
1. l'appareil ne doit pas produire de brouillage, et
2. l'utilisateur de l'appareil doit accepter tout brouillage radioélectrique subi, même si le brouillage
•
•
•
operation of the device.
est susceptible d'en compromettre le fonctionnement.
Flexible fabric, solid fixed size, or disposable ESD wrist straps
Static control workstations, static control monitors and table or floor static control systems
Static control packaging and transportation materials and environmental systems
Regulatory Approval For Canada (IC RSS 210)
Electrostatic Discharge Considerations
Disposal Instructions
26 PART 5 – Appendix
12311 Development Hardware Reference Manual, Rev. 0.0
Freescale Semiconductor