TWR-12311-KIT-NA Freescale Semiconductor, TWR-12311-KIT-NA Datasheet - Page 7

• Manufacturer Part Number: TWR-12311-KIT-NA
• Description: Development Boards & Kits - Other Processors Tower Kit for NA
• Manufacturer: Freescale Semiconductor

Specifications of TWR-12311-KIT-NA

• Rohs: yes
• Product: Development Systems
• Tool Is For Evaluation Of: MC12311
• Core: HCS08
• Interface Type: SPI, USB
• Operating Supply Voltage: 3.5 V to 10 V
• Data Bus Width: 8 bit
• For Use With: MC12311

Chapter 1
Safety Information
1.1
This equipment is for use by developers for evaluation purposes only and must not be incorporated into
any other device or system. This device may not be sold to the general public. Integrators will be
responsible for reevaluating the end product (including the transmitter) and obtaining a separate FCC
authorization.
FCC approval of this device only covers the original configuration of this device as supplied. Any
modifications to this product, including changes shown in this manual, may violate the rules of the Federal
Communications Commission and Industry Canada and make operation of the product unlawful.
1.1.1
FCC labels are physically located on the back of the board.
1.1.2
This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:
1.1.3
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment.
The antenna(s) used for this equipment must be installed to provide a separation distance of at least 8
inches (20cm) from all persons.
1.1.4
An intentional radiator shall be designed to ensure that no antenna other than that furnished by the
responsible party shall be used with the device. The use of a permanently attached antenna or of an
antenna that uses a unique coupling to the intentional radiator shall be considered sufficient to comply with
the provisions of this Section. The manufacturer may design the unit so that a broken antenna can be
replaced by the user, but the use of a standard antenna jack or electrical connector is prohibited. This
requirement does not apply to carrier current devices or to devices operated under the provisions of
Sections 15.211, 15.213, 15.217, 15.219, or 15.221. Further, this requirement does not apply to intentional
Freescale Semiconductor
•
•
This device may not cause harmful interference.
This device must accept any interference received, including interference that may cause undesired
operation.
FCC Guidelines
Labeling
Operating Conditions
Exposure Limits
Antenna Restrictions
12311 Development Hardware Reference Manual, Rev. 0.0
1-1