MICRO-101 Gravitech, MICRO-101 Datasheet - Page 7

• Manufacturer Part Number: MICRO-101
• Description: Development Boards & Kits - PIC / DSPIC MICRO-101 KIT
• Manufacturer: Gravitech

Specifications of MICRO-101

• Rohs: yes
• Product: Development Platforms
• Tool Is For Evaluation Of: PICAXE
• Core: PIC
• Interface Type: USB
• Operating Supply Voltage: 5 V

Your board is ready to be used. Proceed now with the driver installation!
(2) Al three-pin headers. Place each header in the appropriate hole, turn it over
(3) Solder the four diodes, making sure they are oriented correctly. Bend their
(4) Solder the 100uF capacitor, making sure it is oriented correctly.
(5) Solder all the resistors in their correct location. Bend their leads at a 90-
(6) Find a 9-volt battery and snap the connectors to it. Solder the connectors (J2)
(7) Solder J4 and J5. You may have to hold them against a table top. Solder only
(8) Solder the remaining parts as desired.
(9) Peel off the back of the breadboard and align it correctly on location BD1.
and hold it against a table surface and solder only one pin. Then turn it over
and make sure that the header is at 90 degrees to the board. Finally, solder
the other two pins. Repeat for the rest of the headers.
leads at a 90-degree angle. Do not use excessive heat. You may hold them
against a table top so that they do not move around while you solder them. Do
not use excessive heat.
degree angle.
to the board. Remove the battery after soldering.
two pins, making sure that the connector rests correctly and tightly on the
board. Solder the remaining pins.
Make sure it rests squarely on BD1 before you press it down.
MICRO-101 Assembly Instruction Manual
Copyright © 2008 Gravitech
WWW.GRAVITECH.US