MIKROE-419 mikroElektronika, MIKROE-419 Datasheet - Page 6

• Manufacturer Part Number: MIKROE-419
• Description: Development Boards & Kits - PIC / DSPIC BIGPIC6 DEVELOPMENT SYSTEM
• Manufacturer: mikroElektronika

Specifications of MIKROE-419

• Rohs: yes
• Product: Development Kits
• Core: PIC
• Interface Type: ICD, IDC10, JTAG, RS-232, USB
• Operating Supply Voltage: 9 V to 32 V
• Data Bus Width: 8 bit
• Description/function: Development Board Only, Touch Screen, Pencil, DS1820, LCD, Serial Cable, GLCD not included
• Dimensions: 265 mm x 220 mm
• For Use With: PIC

6
1.0. Connecting the System to your PC
Step 1:
Follow the instructions for installing USB drivers and the PICfl ash with mikroICD programmer provided in the relevant manuals. It is
not possible to program PIC microcontrollers without having these devices installed fi rst.
In case you already have some of the MikroElektronika’s compilers installed on your PC, there is no need to reinstall drivers as they
will be automatically installed along with the compiler.
Step 2:
Use the USB cable to connect the BigPIC6 development system to your PC. One end of the USB cable provided with a connector of
the USB B type should be connected to the development system as shown in Figure 1-2, whereas the other end of the cable (USB A
type) should be connected to your PC. When establishing a connection, make sure that jumper J10 is placed in the USB position as
shown in Figure 1-1.
Step 3:
Turn on your development system by setting the POWER SUPPLY switch to the ON position. Two LEDs marked as POWER and USB LINK
will be turned on to indicate that your development system is ready to use. Use the on-board PICfl ash programmer and PICfl ash program
to dump a HEX code into the microcontroller and employ the board to test and develop your projects.
NOTE:
MikroElektronika
J10 power supply
selector
POWER SUPPLY
switch
Figure 1-3: Placing additional modules on the board
If you use additional modules, such as LCD, GLCD etc., it is necessary to place them properly on the develop-
ment board before it is turned on. Otherwise, both additional modules and development system can be permanently damaged.
Refer to Figure 1-3 for their proper placing.
Figure 1-1: Power supply
DC connector
USB connector
Figure 1-2: Connecting USB cable
1
BigPIC6 Development System
BigPIC6 Development System
2