MAX1036EVKIT Maxim Integrated, MAX1036EVKIT Datasheet - Page 3

• Manufacturer Part Number: MAX1036EVKIT
• Description: Data Conversion IC Development Tools
• Manufacturer: Maxim Integrated
• Series: MAX1036, MAX1037, MAX1038, MAX1039r

Specifications of MAX1036EVKIT

• Interface Type: Serial (2-Wire, I2C)

zero and bit SEL1 equals 1 within the Setup Byte.
Then, apply the new reference voltage at the VREF pad
on the board, type in the new reference voltage, without
the volt unit, and press the Set Vref button. The EV kit
software uses the value typed in the Vref field to trans-
late the digital code to a voltage.
When you type on the keyboard, the system must know
which control should receive the keystrokes. Press the
TAB key to move the keyboard’s focus from one control
to the next. The focused control is indicated by a dotted
outline. SHIFT+TAB moves the focus to the previously
focused control. Buttons respond to the keyboard’s
SPACE bar. Some controls respond to the keyboard’s
UP and DOWN arrow keys. Activate the program’s
menu bar by pressing the F10 key, then press the letter
of the menu item you want. Most menu items have one
letter underlined, indicating their shortcut key.
Figure 1. MAX1036 Evaluation Software’s Main Window
_______________________________________________________________________________________
Keyboard Navigation
MAX1036 Evaluation Kit
The MAX1036 is a four-channel (two-differential-channel)
8-bit ADC with a 2-wire serial interface. The open-col-
lector inverter (U2) interfaces the PC parallel port to the
2-wire serial interface. U2 and the associated circuitry
are only required when interfacing to the parallel port.
Power the MAX1036 EV kit from a 5V DC power supply.
The MAX1036 EV kit provides a proven PC board layout
and software to evaluate the features of the MAX1036.
The Windows software only supports a 2-wire serial inter-
face in S-Mode. To evaluate the MAX1036 with a user-
supplied 2-wire serial interface in F-Mode or HS-Mode,
do the following:
1) Disconnect the MAX1036 EV kit from the PC parallel
2) Install 3kΩ resistors at locations R5 and R7. (This
3) Connect the 2-wire bus to the SDA, SCL, and GND
4) Refer to the MAX 1036 data sheet to ensure all tim-
port.
resistor value may require optimization for each
system.)
pads.
ing specifications are met.
User-Supplied 2-Wire Interface
Detailed Description of
Hardware
3