DM330021-2 Microchip Technology, DM330021-2 Datasheet - Page 28

• Manufacturer Part Number: DM330021-2
• Description: Power Management IC Development Tools 64KB Flash, 8KB RAM 16MIPS USBOTG Crypto
• Manufacturer: Microchip Technology
• Type: Motor / Motion Controllers & Driversr

Specifications of DM330021-2

• Rohs: yes
• Product: Development Boards
• Tool Is For Evaluation Of: dsPIC33F, PIC24F, dsPIC33E, PIC24E
• Interface Type: CAN, LIN, RS-232, USB
• For Use With: dsPIC33F, PIC24F, dsPIC33E, PIC24E

dsPICDEM™ MCLV-2 Development Board User’s Guide
3.2
DS52080A-page 28
dsPICDEM MCLV-2 DEVELOPMENT BOARD SETUP
The following procedure describes how to set up the dsPICDEM MCLV-2 Development
Board:
3.2.1
Perform the following steps to set up the development board:
1. Place the dsPICDEM MCLV-2 Development Board on a sturdy insulated
2. Make sure that the dsPIC33EP256MC506 Internal Op Amp Configuration PIM is
3. Insert the Internal Op Amp Configuration matrix board into J14, ensuring that the
FIGURE 3-1:
4. Connect MPLAB ICD 3 or MPLAB REAL ICE In-Circuit Emulator to the computer,
5. Connect the three-phase, 10 pole, 24V Hurst motor (AC300020) to J7. Since this
The dsPICDEM MCLV-2 Development Board is intended to drive the three-phase
BLDC or PMSM motor. Before connecting the motor, make sure that the power rating
of the motor is equal to or less than the power rating of the board, as shown in
dix B. “Electrical
for the firmware programmed into the target dsPIC DSC or PIC24 MCU mounted on
the socket. Failure to comply with this warning could lead to malfunction of the board
and the motor, and could result in physical harm.
Before beginning the start-up procedure, complete a visual check of the board and
the motor for connectivity and mechanical damage. If damage is found, DO NOT
power-up the board. Otherwise, you may further damage the equipment. Contact the
Microchip local office or distributor before using a damaged board.
platform.
mounted in the U9 socket.
pins line up and the matrix board is oriented correctly, as shown in
and the board in J11 or J12.
is a sensorless algorithm, the motor phase wires (Red, Black, and White) can be
connected to M1, M2, and M3 in any order.
Setting up the dsPICDEM MCLV-2 Development Board
Specifications”. Also, make sure the jumper settings are correct
MATRIX BOARD ORIENTATION
WARNING
 2012 Microchip Technology Inc.
Figure
Appen-
3-1.