MOD-RFID1356-BOX Olimex Ltd., MOD-RFID1356-BOX Datasheet - Page 6
![no-image](/images/no-image-200.jpg)
MOD-RFID1356-BOX
Manufacturer Part Number
MOD-RFID1356-BOX
Description
RFID Transponder Tools USB RFID READER FOR 13.56MHz TAGS
Manufacturer
Olimex Ltd.
Datasheet
1.MOD-RFID1356-BOX.pdf
(12 pages)
Specifications of MOD-RFID1356-BOX
Rohs
yes
Product
RFID Readers
Dimensions
50 mm x 20 mm x 5 mm
Frequency
13.56 MHz
Interface Type
USB
Operating Supply Voltage
5 V
Tool Is For Evaluation Of
RFID Tags
For Use With
ISO15693
USB CDC MODE:
SWITCHING OPERATING MODES:
COMMAND LINE INTERFACE (USB CDC mode):
must be changed then device must be switched to USB CDC mode and
configured using the serial command line interface.
In this mode the device represents itself as USB CDC virtual serial port. It
provides a simple shell-like command line interface for configuring and
interacting with the module. The device echoes back the typed characters
and waits for Carriage Return (Enter) before processing the line input. See
“Command Line Interface” for more information on the supported
commands.
Any terminal software can be used to open the COM port, assigned by the
OS, and type in commands.
The current mode of operation can be selected by pressing and holding the
button of the device. After two seconds the LEDs will start to blink and will
show the code for the next selected mode. When button is released, the
device will reboot and enter the selected mode. Selected mode is
remembered between power downs. The assigned codes are:
The command line interface, available in USB CDC mode, allows device
configuration and reading of successfully decoded TAG IDs. Just open the
serial port assigned to MOD-RFID1356 using HyperTerminal or similar
terminal program, and start typing commands.
For the impatient: type '?' and press enter to see a short help for the
supported commands. Any typed character will be echoed back; 'enter' will
force the module to process the input command line.
blinks
off
1.
2.
3.
Red
Command ?
This command prints a short help message, describing the available
commands and their arguments.
Command i
This command prints a short information about firmware version,
hardware board revision, and currently selected configuration.
Command b
This command forces the device to enter boot loader mode. After
executing this command the device will disconnect itself from USB,
switch to boot loader mode, and reconnect itself in anticipation of
LED Status
off
blinks
Green
USB CDC
USB HID
Previous State
Description
State After Button Is
USB HID
USB CDC
Released