MDEV-900-NT Linx Technologies, MDEV-900-NT Datasheet - Page 7

• Manufacturer Part Number: MDEV-900-NT
• Description: RF Development Tools NT Series Dev kit w/ Transparent module
• Manufacturer: Linx Technologies
• Type: RF Transceiversr

Specifications of MDEV-900-NT

• Rohs: yes
• Product: Development Kits
• Tool Is For Evaluation Of: TRM-900-NT
• Frequency: 902 MHz to 928 MHz
• Operating Supply Voltage: 2.5 V to 5.5 V
• Interface Type: USB
• Factory Pack Quantity: 1

Initial Setup
Unpack the development system, attach the antennas and install a 9V
battery on each development board. The boards can be used in two
different configurations: Prototype and Evaluation. The Mode Selection
switch sets the configuration. By default, the boards are set to Range Test
in the Evaluation configuration.
Evaluation Configuration
Setting the Mode Select switch to the EVALUATION (right) position enables
the Evaluation Configuration. In this configuration, the module’s signal lines
are routed to the Evaluation Area for control. This enables the module to be
configured by the controls on the board while allowing custom data to be
sent over the link.
Range Test
The development boards feature an onboard Linx MT Series transcoder
which facilitates range testing. Buttons on one board activate a light or
buzzer on the other. A confirmation LED provides visual acknowledgment
that a transmission was received across the wireless link.
Range Test is part of the Evaluation configuration and is the default
configuration out of the box. To use the boards this way, place the Mode
Select switch to Evaluation and the Evaluation Select switch to the RANGE
TEST (middle) position. This routes the DATA_IN, DATA_OUT and T/R_SEL
lines to the MT Series Transcoder.
Prototype Configuration
Setting the Mode Select switch to the PROTOTYPE (left) position enables
the Prototype Configuration. In the Prototype configuration, the module’s
signal lines are routed to the break-out header next to the Prototype Area.
This allows the module to be controlled with custom application circuitry.
Software Development
The kit includes one USB interface board for connection to a PC. Included
software demonstrates use of the module’s Command Data Interface (CDI).
Troubleshooting
If the boards fail to work out of the box, then try the following:
• Make sure that the Master Power, Mode Select and Evaluation Select
switches are in the correct positions. The Active LED should be on
–
–
3