MAX17502ETEVKIT# Maxim Integrated, MAX17502ETEVKIT# Datasheet - Page 2

• Manufacturer Part Number: MAX17502ETEVKIT#
• Description: Power Management IC Development Tools MAX17502E Eval Kit
• Manufacturer: Maxim Integrated
• Type: DC/DC Converters, Regulators & Controllersr
• Series: MAX17502r

Specifications of MAX17502ETEVKIT#

• Rohs: yes
• Product: Evaluation Kits
• Tool Is For Evaluation Of: MAX17502E
• Input Voltage: 4.5 V to 60 V
• Output Voltage: 3.3 V
• Output Current: 1 A
• For Use With: MAX17502E

Note: Indicate that you are using the MAX17502 when contacting these component suppliers.
• MAX17502E EV kit
• 4.5V to 60V, 2A DC input power supply
• Load capable of sinking 1A
• Digital voltmeter (DVM)
• Function generator
The EV kit is fully assembled and tested. Follow the steps
below to verify board operation. Caution: Do not turn on
power supply until all connections are completed.
1) Set the power supply at a voltage between 4.5V and
2) Connect the positive terminal of the power supply
3) Connect the DVM across the VOUT PCB pad and the
Maxim Integrated
Coilcraft, Inc.
Murata Electronics North America, Inc.
Panasonic Corp.
60V. Disable the power supply.
to the VIN PCB pad and the negative terminal to the
nearest PGND PCB pad. Connect the positive ter-
minal of the 1A load to the VOUT PCB pad and the
negative terminal to the nearest PGND PCB pad.
nearest PGND PCB pad.
SUPPLIER
Recommended Equipment
Evaluate: MAX17502E in TDFN Package
Quick Start
Procedure
847-639-6400
770-436-1300
800-344-2112
MAX17502E Evaluation Kit
PHONE
4) Verify that a shunt is installed across pins 1-2 on
5) Turn on the DC power supply.
6) Enable the load.
7) Verify that the DVM displays the expected voltage.
To turn on/turn off the part from EN/UVLO, follow the
steps below:
1) Remove resistors R1 and R2 and the jumper installed
2) Connect the power supply to the EV kit and turn on
3) Connect the function generator output to the
4) EN/UVLO rising threshold is 1.24V and falling thresh-
5) When powering down the EV kits, first disconnect the
jumper JU1.
across pins 1-2 on jumper JU1.
the power supply. Set the power supply at a voltage
between 4.5V and 60V.
EN/UVLO test loop.
old is 1.11V. Make sure that the voltage-high and
voltage-low levels of the function generator output are
greater than 1.24V and less than 1.11V, respectively.
function generator output from the EN/UVLO test loop
and then turn off the DC power supply.
www.coilcraft.com
www.murata-northamerica.com
www.panasonic.com
Component Suppliers
WEBSITE
2