450-0018 LS Research, 450-0018 Datasheet - Page 25
![no-image](/images/no-image-200.jpg)
450-0018
Manufacturer Part Number
450-0018
Description
Zigbee / 802.15.4 Modules SiFLEX02 Zigbee Mod 900 Mhz helical ant
Manufacturer
LS Research
Datasheet
1.450-0019.pdf
(40 pages)
Specifications of 450-0018
Rohs
yes
Frequency Band
900 MHz
Line Of Sight Range
2 miles
Data Rate
1 Mbps
Sensitivity
- 102 dBm
Operating Supply Voltage
2 V to 3.45 V
Supply Current Transmitting
285 mA
Supply Current Receiving
30 mA
Output Power
250 mW
Antenna Connector Type
Helical
Maximum Operating Temperature
+ 85 C
Dimensions
1.63 in x 0.9 in x 0.2 in
Minimum Operating Temperature
- 40 C
Factory Pack Quantity
50
AGENCY STATEMENTS
Federal Communication Commission Interference Statement
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates uses and can radiate
radio frequency energy and, if not installed and used in accordance with the instructions, may cause
harmful interference to radio communications. However, there is no guarantee that interference will not
occur in a particular installation. If this equipment does cause harmful interference to radio or television
reception, which can be determined by turning the equipment off and on, the user is encouraged to try
to correct the interference by one of the following measures:
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) This device may not cause harmful interference, and (2) this device must accept any
interference received, including interference that may cause undesired operation.
The information in this document is subject to change without notice.
330-0009-R3.1
FCC CAUTION: Any changes or modifications not expressly approved by the party
responsible for compliance could void the user's authority to operate this equipment.
Reorient or relocate the receiving antenna.
Increase the separation between the equipment and receiver.
Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
Consult the dealer or an experienced radio/TV technician for help.
Copyright © 2009-2012 LS Research, LLC
SiFLEX02 TRANSCEIVER MODULE
DATASHEET
Page 25 of 40