M29W640GL70NB6E NUMONYX, M29W640GL70NB6E Datasheet - Page 14

• Manufacturer Part Number: M29W640GL70NB6E
• Description: IC FLASH 64MBIT 70NS 56TSOP
• Manufacturer: NUMONYX
• Series: Axcell™r

Specifications of M29W640GL70NB6E

• Format - Memory: FLASH
• Memory Type: FLASH - Nor
• Memory Size: 64M (8Mx8, 4Mx16)
• Speed: 70ns
• Interface: Parallel
• Voltage - Supply: 2.7 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 56-TSOP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

2
2.1
2.2
2.3
2.4
2.5
2.6
14/90
Signal descriptions
See
connected to the device.
Address Inputs (A0-A21)
The Address Inputs select the cells in the memory array to access during bus read
operations. During bus write operations they control the commands sent to the command
interface of the program/erase controller.
Data Inputs/Outputs (DQ0-DQ7)
The Data I/O outputs the data stored at the selected address during a bus read operation.
During bus write operations they represent the commands sent to the command interface of
the program/erase controller.
Data Inputs/Outputs (DQ8-DQ14)
The Data I/O outputs the data stored at the selected address during a bus read operation
when BYTE is High, V
impedance. During bus write operations the command register does not use these bits.
When reading the status register these bits should be ignored.
Data Input/Output or Address Input (DQ15A–1)
When BYTE is High, V
When BYTE is Low, V
LSB of the addressed word, DQ15A–1 High will select the MSB. Throughout the text
consider references to the Data Input/Output to include this pin when BYTE is High and
references to the Address Inputs to include this pin when BYTE is Low except when stated
explicitly otherwise.
Chip Enable (E)
The Chip Enable, E, activates the memory, allowing bus read and bus write operations to be
performed. When Chip Enable is High, V
Output Enable (G)
The Output Enable, G, controls the bus read operation of the memory.
Figure 1: Logic
diagram, and
IL
IH
IH
, this pin behaves as an address pin; DQ15A–1 Low will select the
. When BYTE is Low, V
, this pin behaves as a Data Input/Output pin (as DQ8-DQ14).
Table 2: Signal
IH
, all other pins are ignored.
IL
, these pins are not used and are high
names, for a brief overview of the signals