RC28F256P33TFE NUMONYX, RC28F256P33TFE Datasheet - Page 20

• Manufacturer Part Number: RC28F256P33TFE
• Description: IC FLASH 256MBIT 64EZBGA
• Manufacturer: NUMONYX
• Series: Axcell™r

Specifications of RC28F256P33TFE

• Format - Memory: FLASH
• Memory Type: FLASH
• Memory Size: 256M (16Mx16)
• Speed: 95ns
• Interface: Parallel
• Voltage - Supply: 2.3 V ~ 3.6 V
• Operating Temperature: -40°C ~ 85°C
• Package / Case: 64-EZBGA
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant

Table 7:
Datasheet
20
Notes:
1.
2.
3.
4.
5.
Others
Mode
First command cycle address should be the same as the operation’s target address.
DBA = Device Base Address (NOTE: needed for dual-die 512Mbit device)
DnA = Address within the device.
IA = Identification code address offset.
CFI-A = Read CFI address offset.
WA = Word address of memory location to be written.
BA = Address within the block.
OTP-RA = OTP register address.
LRA = Lock Register address.
RCD = Read Configuration Register data on A[16:1].
ID = Identifier data.
CFI-D = CFI data on DQ[15:0].
SRD = Status Register data.
WD = Word data.
N = Word count of data to be loaded into the write buffer.
OTP-D = OTP register data.
LRD = Lock Register data.
The second cycle of the Buffered Program Command is the word count of the data to be loaded into the write buffer. This
is followed by up to 512 words of data.Then the confirm command (0xD0) is issued, triggering the array programming
operation.
The confirm command (0xD0) is followed by the buffer data.
The second cycle is a Sub-Op-Code, the data written on third cycle is N-1; 1=< N <=512. The subsequent cycles load
data words into the program buffer at a specified address until word count is achieved, after the data words are loaded,
the final cycle is the confirm cycle 0xD0)
Command Bus Cycles (Sheet 2 of 2)
Blank Check
Extended Function
Interface
command
Command
(5)
Cycles
Bus
>2
2
Oper
Write
Write
First Bus Cycle
Addr
WA
BA
(1)
Data
0xBC
0xEB
(2)
Oper
Write
Write
Second Bus Cycle
Order Number: 320003-09
Addr
WA
BA
(1)
P33-65nm
Data
Sub-Op
code
Mar 2010
D0
(2)