AT93C56-10SC-2.7 Atmel, AT93C56-10SC-2.7 Datasheet
![IC EEPROM 2KBIT 2MHZ 8SOIC](/photos/6/50/65032/453-8-soic_sml.jpg)
AT93C56-10SC-2.7
Specifications of AT93C56-10SC-2.7
Available stocks
Related parts for AT93C56-10SC-2.7
AT93C56-10SC-2.7 Summary of contents
Page 1
... GND and 128/256/512 words of 8 bits CC (continued) 8-pin PDIP VCC ORG GND 8-lead SOIC VCC ORG GND 8-lead TSSOP VCC ORG GND 3-wire Serial EEPROMs 1K (128 16) 2K (256 128 x 16) 4K (512 256 x 16) AT93C46 AT93C56 AT93C57 AT93C66 Rev. 0172L–10/99 1 ...
Page 2
... WRITE cycle, the DO pin out- puts the READY/BUSY status of the part. The AT93C46 is available in 4.5V to 5.5V, 2.7V to 5.5V AT93C56/57/66 is available in 4.5V to 5.5V, 2.7V to 5.5V, and 2.5V to 5.5V versions. *NOTICE: Stresses beyond those listed under “Absolute Maximum Ratings” may cause permanent dam- age to the device ...
Page 3
Pin Capacitance Applicable over recommended operating range from T Symbol Test Conditions C Output Capacitance (DO) OUT C Input Capacitance (CS, SK, DI) IN Note: 1. This parameter is characterized and is not 100% tested. DC Characteristics Applicable over ...
Page 4
AC Characteristics Applicable over recommended operating range from TTL Gate and 100 pF (unless otherwise noted). Symbol Parameter SK Clock f SK Frequency t SK High Time SKH t SK Low Time SKL Minimum CS t ...
Page 5
... 10XXXXX 01XXXXX 00XXXXX AT93C46/56/57/66 Data x 16 Comments Reads data stored in memory, at specified address. Write enable must precede all programming modes. Erase memory location Writes memory location Erases all memory locations. Valid only 4.5V to 5.5V Writes all memory locations. Valid 15 0 only ...
Page 6
... Instruction Set for the AT93C56 and AT93C66 Op Instruction SB Code READ 1 10 EWEN 1 00 11XXXXXXX ERASE 1 11 WRITE 1 01 ERAL 1 00 10XXXXXXX WRAL 1 00 01XXXXXXX EWDS 1 00 00XXXXXXX Functional Description The AT93C46/56/57/66 is accessed via a simple and ver- satile 3-wire serial communication interface. Device opera- tion is controlled by seven instructions issued by the host processor ...
Page 7
... Synchronous Data Timing Note: 1. This is the minimum SK period. Organization Key for Timing Diagrams AT93C46 (1K) I Note DON’T CARE value, but the extra clock is required DON’T CARE value, but the extra clock is required. 7 READ Timing AT93C56 (2K (1) ( AT93C46/56/57/66 AT93C57 (2K) AT93C66 (4K ...
Page 8
EWEN Timing EWDS Timing WRITE Timing HIGH IMPEDANCE DO (1) WRAL Timing HIGH IMPEDANCE DO Note: 1. Valid only 4.5V to 5.5V. CC AT93C46/56/57/66 8 ...
Page 9
ERASE Timing HIGH IMPEDANCE DO (1) TERAL Timing HIGH IMPEDANCE DO Note: 1. Valid only 4.5V to 5.5V ... N-1 N-2 ...
Page 10
AT93C46 Ordering Information t (max) I (max) I (max (ms) (µA) (µA) 10 2000 30.0 30.0 10 800 10.0 10.0 8P3 8-pin, 0.300" Wide, Plastic Dual Inline Package (PDIP) 8S1 8-lead, 0.150" Wide, Plastic Gull Wing Small ...
Page 11
AT93C46 Ordering Information (Continued) t (max) I (max) I (max (ms) (µA) (µA) 10 600 10.0 10 0.1 0.1 8P3 8-pin, 0.300" Wide, Plastic Dual Inline Package (PDIP) 8S1 8-lead, 0.150" Wide, Plastic Gull Wing ...
Page 12
... Low Voltage (2.5V to 5.5V) AT93C46/56/57/ MAX (kHz) Ordering Code 2000 AT93C56-10PC AT93C56-10SC AT93C56W-10SC 2000 AT93C56-10PI AT93C56-10SI AT93C56W-10SI 1000 AT93C56-10PC-2.7 AT93C56-10SC-2.7 AT93C56W-10SC-2.7 1000 AT93C56-10PI-2.7 AT93C56-10SI-2.7 AT93C56W-10SI-2.7 500 AT93C56-10PC-2.5 AT93C56-10SC-2.5 AT93C56W-10SC-2.5 500 AT93C56-10PI-2.5 AT93C56-10SI-2.5 AT93C56W-10SI-2.5 Package Type Options Package Operation Range 8P3 ...
Page 13
AT93C57 Ordering Information t (max) I (max) I (max (ms) (µA) (µA) 10 2000 30.0 30.0 10 800 10.0 10.0 8P3 8-pin, 0.300" Wide, Plastic Dual Inline Package (PDIP) 8S1 8-lead, 0.150" Wide, Plastic Gull Wing Small ...
Page 14
AT93C66 Ordering Information t (max) I (max) I (max (ms) (µA) (µA) 10 2000 30.0 30.0 10 800 10.0 10.0 10 600 10.0 10.0 8P3 8-pin, 0.300" Wide, Plastic Dual Inline Package (PDIP) 8S1 8-lead, 0.150" Wide, ...
Page 15
Packaging Information 8P3, 8-pin, 0.300" Wide, Plastic Dual Inline Package (PDIP) Dimensions in Inches and (Millimeters) JEDEC STANDARD MS-001 BA .400 (10.16) .355 (9.02) PIN 1 .300 (7.62) REF .210 (5.33) MAX .100 (2.54) BSC SEATING PLANE .150 (3.81) .115 ...
Page 16
... No licenses to patents or other intellectual prop- erty of Atmel are granted by the Company in connection with the sale of Atmel products, expressly or by implication. Atmel’s products are not authorized for use as critical components in life suppor t devices or systems. ...