AT17F16-30JI Atmel, AT17F16-30JI Datasheet - Page 7
![IC FLASH CONFIG 16M 20PLCC](/photos/6/80/68044/453-20-plcc_sml.jpg)
AT17F16-30JI
Manufacturer Part Number
AT17F16-30JI
Description
IC FLASH CONFIG 16M 20PLCC
Manufacturer
Atmel
Datasheet
1.AT17F16-30JU.pdf
(20 pages)
Specifications of AT17F16-30JI
Programmable Type
FLASH
Memory Size
16Mb
Voltage - Supply
2.97 V ~ 3.63 V
Operating Temperature
-40°C ~ 85°C
Package / Case
20-LCC (J-Lead)
Lead Free Status / RoHS Status
Contains lead / RoHS non-compliant
Available stocks
Company
Part Number
Manufacturer
Quantity
Price
6. FPGA Master Serial Mode Summary
7. Control of Configuration
8. Cascading Serial Configuration Devices
3392F–CNFG–2/08
The I/O and logic functions of any SRAM-based FPGA are established by a configuration pro-
gram. The program is loaded either automatically upon power-up, or on command, depending
on the state of the FPGA mode pins. In Master mode, the FPGA automatically loads the config-
uration program from an external memory. The AT17F Serial Configuration PROM has been
designed for compatibility with the Master Serial mode.
This document discusses the Atmel AT40K, AT40KAL and AT94KAL applications as well as Xil-
inx applications.
Most connections between the FPGA device and the AT17F Serial Configurator PROM are sim-
ple and self-explanatory.
For multiple FPGAs configured as a daisy-chain, or for FPGAs requiring larger configuration
memories, cascaded configurators provide additional memory.
After the last bit from the first configurator is read, the clock signal to the configurator asserts its
CEO output Low and disables its DATA line driver. The second configurator recognizes the Low
level on its CE input and enables its DATA output.
After configuration is complete, the address counters of all cascaded configurators are reset if
the RESET/OE on each configurator is driven to its active (Low) level.
If the address counters are not to be reset upon completion, then the RESET/OE input can be
tied to its inactive (High) level.
• The DATA output of the AT17F Series Configurator drives DIN of the FPGA devices.
• The master FPGA CCLK output drives the CLK input of the AT17F Series Configurator.
• The CEO output of any AT17F Series Configurator drives the CE input of the next
• SER_EN must be connected to V
• The READY pin is available as an open-collector indicator of the device’s reset status; it is
• PAGE_EN must be held Low if download paging is not desired. The PAGESEL[1:0] inputs
Configurator in a cascade chain of configurator devices.
resistor (except during ISP).
driven Low while the device is in its power-on reset cycle and released (tri-stated) when the
cycle is complete.
must be tied off High or Low. If paging is desired, PAGE_EN must be High and the PAGESEL
pins must be set to High or Low such that the desired page is selected, see
page
5.
CC
or allowed to float to logic High via the internal pull-up
AT17F16
Table 5-2 on
7