ABMT-A-C Panduit Corp, ABMT-A-C Datasheet - Page 4
ABMT-A-C
Manufacturer Part Number
ABMT-A-C
Description
ADH. MNT FOR 3/4" TAK-TY
Manufacturer
Panduit Corp
Type
Dual Openingr
Specifications of ABMT-A-C
Mounting Type
Screw, #6, Adhesive
Size / Dimension
1.12" L x 1.12" W x 0.34" H (28.4mm x 28.4mm x 8.6mm)
Color
Natural
Mounting Method
Adhesive
Height
8.64 mm
Length
28.45 mm
Width
27.94 mm
Rohs Compliant
Yes
Application
For indoor use
Protection Class
Mount, Cable Tie
Size, Thread
M3
Special Features
Adhesive Backed
For Use With/related Products
HTL/HLS Tak-Ty® Hook & Loop Ties
Lead Free Status / Rohs Status
Lead free / RoHS Compliant
4
Proper Installation Steps
Surface Preparation
For best results, mounts should be applied to a clean, dry, and grease-free surface. It is recommended that for each individual application,
a solvent or cleanser be used to thoroughly prepare the surface for mount installation. The following are recommended cleaning guidelines:
Installing the Mount
9
12
6
Alcohol
3
1. For Rubber and Acrylic-based Adhesive Foam Tape, a mixture of water and isopropyl alcohol may be used on
2. Allow the surface to dry completely before applying the mount.
1. For proper installation of adhesive backed mounts with foam tape, remove the release liner from the foam
2. Apply firm pressure for five (5) seconds to the foam tape mounts to insure proper adhesion.
3. Allow the mount to remain in place for the recommended dwell time for the specific adhesive being used.
4. The mount is now ready to be used.
most surfaces.
For Two-part Epoxy Adhesive, especially on masonry surfaces, be sure to clean all loose particles away before
mount installation. Some surface abrasion is recommended on smooth surfaces to achieve maximum strength.
A light rubbing with medium grit emery cloth or sandpaper is best. Wash the surface after abrading.
adhesive. Without touching the adhesive, place the mount in the desired location.
For Two-part Epoxy Adhesive Mounts, apply 1/3 of the mixed adhesive to the bottom of the PANDUIT
ASMS mount. Without touching the adhesive, place the mount in the desired location.
Two-part Epoxy Adhesive Mounts should be twisted in place to ensure the adhesive is forced into the
porous surface.
The dwell time for Rubber-based Adhesive Foam Tape is two (2) hours and for Acrylic-based Adhesive Foam
Tape it is eight (8) hours.
Two-part Epoxy Adhesive Mounts can support about 5 lbs. after first fifteen (15) minutes. The adhesive fully
cures after twenty-four (24) hours and bonding strength will exceed 50 lbs.
®
EMS or