MAX14544ETA+T Maxim Integrated Products, MAX14544ETA+T Datasheet
MAX14544ETA+T
Specifications of MAX14544ETA+T
Related parts for MAX14544ETA+T
MAX14544ETA+T Summary of contents
Page 1
... TDFN (2mm x 2mm) Package S -40NC to +85NC Operating Temperature Range S Ordering Information/ PIN- PART PACKAGE MAX14544ETA+T 8 TDFN-EP* MAX14545ETA+T 8 TDFN-EP* Note: All devices are specified over the -40°C to +85°C tem- perature range. +Denotes a lead(Pb)-free/RoHS-compliant package Tape and reel. *EP = Exposed pad. ...
Page 2
I ABSOLUTE MAXIMUM RATINGS (Voltages referenced to GND.) OUT .......................................................................-0.3V to +30V IN, FLAG, EN, ISET ..............................................-0.3V to +6.0V Continuous Power Dissipation (T = +70NC) A 8-Pin TDFN (derate 11.9mW/NC above +70NC) ...........953mW Junction-to-Ambient Thermal Resistance (Note 1) ..............................................................83.9NC/W ...
Page 3
I ELECTRICAL CHARACTERISTICS (continued +2.3V to +5.5V -40NC to +85NC, unless otherwise noted. Typical values are PARAMETER SYMBOL Input Logic-High Voltage Input Logic-Low Voltage Input Leakage Output Logic-Low Voltage Output High ...
Page 4
I CURRENT LIMIT LOAD CURRENT ON SWITCH OFF FLAG ON EN OFF Figure 1. MAX14544 Timing Diagram (Waveforms Not to Scale) CURRENT LIMIT LOAD CURRENT Figure 2. MAX14545 Timing Diagram (Waveforms Not to Scale Accessory Switch LIM ...
Page 5
+3.3V 10FF 1FF OUT QUIESCENT SUPPLY CURRENT vs. SUPPLY VOLTAGE 450 400 350 300 250 200 150 100 50 0 2.3 2.7 3.1 3.5 ...
Page 6
+3.3V 10FF 1FF OUT SWITCH TURN-ON TIME vs. TEMPERATURE 100Ω -40 ...
Page 7
I PIN NAME Input Voltage. Connect IN pins 1 and 2 together and bypass IN to GND with a 10FF ceramic capacitor close to the device as possible. Current-Limit Setting. Drive ISET low to have ...
Page 8
I Detailed Description The MAX14544/MAX14545 are overcurrent detection switches that prevent host devices from being damaged due to faulty load conditions. The switch opens if current exceeds the current limit for longer than the blanking time ...
Page 9
I fault-blanking timeout, FLAG asserts low. FLAG is not asserted when load-transient fault is less than t The fault blanking time only applies to forward current- limit faults. A reverse current-limit fault, thermal fault, or OVP fault causes FLAG ...
Page 10
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 10 Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 2010 Maxim Integrated Products © ...