MIC2583-KBQS TR Micrel Inc, MIC2583-KBQS TR Datasheet - Page 4

• Manufacturer Part Number: MIC2583-KBQS TR
• Description: IC CTRLR HOT SWAP 100MV 16-QSOP
• Manufacturer: Micrel Inc
• Type: Hot-Swap Controllerr

Specifications of MIC2583-KBQS TR

• Applications: General Purpose
• Internal Switch(s): No
• Voltage - Supply: 2.3 V ~ 13.2 V
• Operating Temperature: -40°C ~ 85°C
• Mounting Type: Surface Mount
• Package / Case: 16-SSOP (0.150", 3.90mm Width)
• Linear Misc Type: Positive Low Voltage
• Family Name: MIC2583
• Package Type: QSOP
• Operating Supply Voltage (min): 2.3V
• Operating Supply Voltage (max): 13.2V
• Operating Temperature (min): -40C
• Operating Temperature (max): 85C
• Operating Temperature Classification: Industrial
• Product Depth (mm): 3.99mm
• Product Height (mm): 1.4mm
• Product Length (mm): 4.98mm
• Mounting: Surface Mount
• Pin Count: 16
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: MIC2583-KBQSTR; MIC2583-KBQSTR

Micrel, Inc.
April 2009
Pin Number
8-Pin SOIC
n/a
n/a
n/a
n/a
n/a
16-Pin QSOP
Pin Number
6, 9, 10
11
13
2
5
Pin Name
CFILTER
PWRGD
/FAULT
DIS
NC
Pin Name
Power-Good Output: Open drain N-channel device, Active High. When the
voltage at the FB pin is lower than 1.24V, PWRGD output is held low. When the
voltage at the FB pin exceeds 1.24V, then PWRGD is asserted immediately. The
PWRGD pin requires a pull-up resistor (10kΩ minimum) to VCC.
Current Limit Response Timer: A capacitor connected to this pin defines the
period of time (t
condition and trip the circuit breaker. If no capacitor is connected, then t
defaults to 5µs.
Circuit Breaker Fault Status Output: Open drain N-channel device, Active Low.
The /FAULT pin is asserted when the circuit breaker trips due to an over current
condition or when an under-voltage lockout condition exists. The/FAULT pin
requires a pull-up resistor (10kΩ minimum) to VCC.
Discharge Output: When the MIC2583/83R is turned off, a 500Ω internal resistor
at this output allows the discharging of any load capacitance to ground.
No internal connection.
OCSLOW
4
) in which an over current event must last to signal a fault
MIC2582/MIC2583
M9999-043009-C
OCSLOW