LM75BIM-3+ Maxim Integrated Products, LM75BIM-3+ Datasheet
LM75BIM-3+
Specifications of LM75BIM-3+
Related parts for LM75BIM-3+
LM75BIM-3+ Summary of contents
Page 1
... TOP VIEW + SDA 1 SCL 2 7 LM75 OS 3 GND 4 5 μMAX (μSOP), SO PART PIN-PACKAGE LM75BIM- (SOP) LM75BIMX- (SOP) LM75BIMM-3+ 8 µMAX (µSOP) LM75BIMMX-3+ 8 µMAX (µSOP) LM75BIM- (SOP) LM75BIMX- (SOP) LM75BIMM-5+ 8 µMAX (µSOP) LM75BIMMX-5+ 8 µMAX (µSOP) Note: Devices are specified over the -55°C to +125°C temperature range and include I + Denotes a lead(Pb)-free/RoHS-compliant package. T& ...
Page 2
Digital Temperature Sensor and Thermal Watchdog with 2-Wire Interface ABSOLUTE MAXIMUM RATINGS (Note GND ...........................................................-0.3V to +6.0V S OS, SDA, SCL to GND...........................................-0.3V to +6.0V All Other Pins to GND .................................-0.3V to (+V Input Current at Any ...
Page 3
... SCL to 10% of SDA 90% of SCL to 90% of SDA (Note 14) = +25°C. Values over the temperature range are guaranteed by design +5VDC for LM75BIM-5 and LM75BIMM-5 and +V S (load capacitance) on output lines = 80pF, unless otherwise specified. L causes the device to reset SDA to the IDLE state of the TIMEOUT = 3.3V for versions with “ ...
Page 4
Digital Temperature Sensor and Thermal Watchdog with 2-Wire Interface (T = +25°C, unless otherwise noted.) A QUIESCENT SUPPLY CURRENT vs. TEMPERATURE 300 290 280 +V = +5V S 270 260 +V = +3V S 250 240 230 -55 -25 5 ...
Page 5
Digital Temperature Sensor and Thermal Detailed Description The LM75 temperature sensor measures temperature and converts the data into digital form using a band- gap type temperature sensor and a 9-bit delta-sigma 2 ADC C-compatible 2-wire serial interface allows ...
Page 6
Digital Temperature Sensor and Thermal Watchdog with 2-Wire Interface SDA t SU:DAT t LOW SCL t HIGH t HD:STA START CONDITION (S) PARAMETERS ARE MEASURED FROM 10% TO 90%. Figure 2. Serial Bus Timing Table 3. ...
Page 7
Digital Temperature Sensor and Thermal 2 Figure 4. I C-Compatible Timing Diagram (Read) _______________________________________________________________________________________ Watchdog with 2-Wire Interface 7 ...
Page 8
Digital Temperature Sensor and Thermal Watchdog with 2-Wire Interface 2 Figure 5. I C-Compatible Timing Diagram (Write) 8 _______________________________________________________________________________________ ...
Page 9
Digital Temperature Sensor and Thermal Temperature Data Format Temperature data is stored in the Temperature, T Point, and T Set Point registers. The temperature HYST data format is 9 bits, two’s complement, and the register is read out in 2 ...
Page 10
Digital Temperature Sensor and Thermal Watchdog with 2-Wire Interface Table 5. Configuration Register Definition Configuration Register The 8-bit Configuration register sets the fault queue, OS polarity, shutdown control, and whether the OS output functions in comparator ...
Page 11
Digital Temperature Sensor and Thermal GND A0 10kΩ 10kΩ 10kΩ SCL SCL SDA SDA TO Microcontroller OS 2 Figure Controlled Temperature Sensor 3V to 5.5V R1 10kΩ ...
Page 12
... Maxim cannot assume responsibility for use of any circuitry other than circuitry entirely embodied in a Maxim product. No circuit patent licenses are implied. Maxim reserves the right to change the circuitry and specifications without notice at any time. 12 ____________________Maxim Integrated Products, 120 San Gabriel Drive, Sunnyvale, CA 94086 408-737-7600 © 2009 Maxim Integrated Products ...