LM2595DSADJR4G ON Semiconductor, LM2595DSADJR4G Datasheet - Page 3

• Manufacturer Part Number: LM2595DSADJR4G
• Description: IC REG SW 1A STEPDOWN D2PAK-5
• Manufacturer: ON Semiconductor
• Type: Step-Down (Buck)r

Specifications of LM2595DSADJR4G

• Internal Switch(s): Yes
• Synchronous Rectifier: No
• Number Of Outputs: 1
• Voltage - Output: 1.2 ~ 37 V
• Current - Output: 1A
• Frequency - Switching: 150kHz
• Voltage - Input: 4.5 ~ 40 V
• Operating Temperature: -40°C ~ 125°C
• Mounting Type: Surface Mount
• Package / Case: D²Pak, TO-263 (5 leads + tab)
• Output Voltage: 1.23 V to 37 V
• Output Current: 1 A
• Input Voltage: 4.75 V to 40 V
• Switching Frequency: 150 KHz
• Operating Temperature Range: - 40 C to + 125 C
• Mounting Style: SMD/SMT
• Duty Cycle (max): 95 %
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Power - Output: -
• Lead Free Status / Rohs Status: Lead free / RoHS Compliant

PIN FUNCTION DESCRIPTION
OPERATING RATINGS
specific performance limits. For guaranteed specifications and test conditions, see the Electrical Characteristics.)
Pin
Operating Junction Temperature Range
Supply Voltage
1
2
3
4
5
Feedback
ON/OFF
Symbol
Output
GND
V
in
This is the emitter of the internal switch. The saturation voltage V
kept in mind that the PCB area connected to this pin should be kept to a minimum in order to minimize coupling to
sensitive circuitry.
This pin is the positive input supply for the LM2595 step−down switching regulator. In order to minimize voltage transi-
ents and to supply the switching currents needed by the regulator, a suitable input bypass capacitor must be present
(C
Circuit ground pin. See the information about the printed circuit board layout.
This pin is the direct input of the error amplifier and the resistor network R2, R1 is connected externally to allow pro-
gramming of the output voltage.
It allows the switching regulator circuit to be shut down using logic level signals, thus dropping the total input supply
current to approximately 50 mA. The threshold voltage is typically 1.6 V. Applying a voltage above this value (up to
+V
will be in the “on” condition.
in
in
) shuts the regulator off. If the voltage applied to this pin is lower than 1.6 V or if this pin is left open, the regulator
in Figure 1).
(Operating Ratings indicate conditions for which the device is intended to be functional, but do not guarantee
Rating
http://onsemi.com
Description (Refer to Figure 1)
3
sat
of this output switch is typically 1.0 V. It should be
Symbol
V
T
in
J
−40 to +125
4.5 to 40
Value
Unit
°C
V