PS2911-1-K-A CEL, PS2911-1-K-A Datasheet - Page 9
![PHOTOCOUPLER 1CH TRANS OUT SM](/photos/7/69/76905/ps2911-1-k-a_sml.jpg)
PS2911-1-K-A
Manufacturer Part Number
PS2911-1-K-A
Description
PHOTOCOUPLER 1CH TRANS OUT SM
Manufacturer
CEL
Series
NEPOCr
Datasheet
1.PS2911-1-M-A.pdf
(12 pages)
Specifications of PS2911-1-K-A
Number Of Channels
1
Input Type
DC
Voltage - Isolation
2500Vrms
Current Transfer Ratio (min)
200% @ 1mA
Current Transfer Ratio (max)
400% @ 1mA
Voltage - Output
40V
Current - Output / Channel
40mA
Current - Dc Forward (if)
50mA
Vce Saturation (max)
300mV
Output Type
Transistor
Mounting Type
Surface Mount
Package / Case
4-SMD
Maximum Fall Time
10 us
Maximum Input Diode Current
50 mA
Maximum Reverse Diode Voltage
6 V
Maximum Rise Time
5 us
Maximum Collector Emitter Voltage
40 V
Maximum Collector Emitter Saturation Voltage
0.3 V
Isolation Voltage
2500 Vrms
Current Transfer Ratio
400 %
Maximum Forward Diode Voltage
1.3 V
Maximum Collector Current
40 mA
Maximum Power Dissipation
120 mW
Maximum Operating Temperature
+ 100 C
Minimum Operating Temperature
- 55 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
<R>
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
(2) Wave soldering
(3) Soldering by soldering iron
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120˚C
(preheating)
120±30 s
Data Sheet PN10061EJ02V0DS
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
180˚C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
260˚C MAX.
220˚C
PS2911-1
9