LOC110 Clare, LOC110 Datasheet - Page 4

• Manufacturer Part Number: LOC110
• Description: OPTOCOUPLER TRANSISTOR 8-DIP
• Manufacturer: Clare

Specifications of LOC110

• Number Of Channels: 1
• Input Type: DC
• Voltage - Isolation: 3750Vrms
• Current Transfer Ratio (min): 0.55% @ 2mA ~ 10mA
• Current Transfer Ratio (max): 1.43% @ 2mA ~ 10mA
• Current - Dc Forward (if): 100mA
• Output Type: Linear Phototransistor
• Mounting Type: Through Hole
• Package / Case: 8-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Voltage - Output: -
• Current - Output / Channel: -
• Vce Saturation (max): -
• Other names: CLA113

Manufacturing Information
Moisture Sensitivity
the maximum conditions set forth in the standard, and guarantee proper operation of our devices when handled
according to the limitations and information in that standard as well as to any limitations set forth in the information or
standards referenced below.
Failure to adhere to the warnings or limitations as established by the listed specifications could result in reduced
product performance, reduction of operable life, and/or reduction of overall reliability.
This product carries a Moisture Sensitivity Level (MSL) rating as shown below, and should be handled according
to the requirements of the latest version of the joint industry standard IPC/JEDEC J-STD-033.
ESD Sensitivity
Reflow Profile
This product has a maximum body temperature and time rating as shown below. All other guidelines of J-STD-020
must be observed.
Board Wash
Clare recommends the use of no-clean flux formulations. However, board washing to remove flux residue is
acceptable. Since Clare employs the use of silicone coating as an optical waveguide in many of its optically isolated
products, the use of a short drying bake could be necessary if a wash is used after solder reflow processes.
Chlorine- or Fluorine-based solvents or fluxes should not be used. Cleaning methods that employ ultrasonic energy
should not be used.
4
Pb
All plastic encapsulated semiconductor packages are susceptible to moisture ingression. Clare classified all
of its plastic encapsulated devices for moisture sensitivity according to the latest version of the joint industry
standard, IPC/JEDEC J-STD-020, in force at the time of product evaluation. We test all of our products to
This product is ESD Sensitive, and should be handled according to the industry standard JESD-625.
2002/95/EC
RoHS
LOC110 / LOC110P / LOC110S
e
3
LOC110 / LOC110S
LOC110P
Device
Device
www.clare.com
Moisture Sensitivity Level (MSL) Rating
Maximum Temperature x Time
260ºC for 30 seconds
250ºC for 30 seconds
MSL 1
LOC110
R08