PS2701-1-F3-L-A CEL, PS2701-1-F3-L-A Datasheet - Page 10
![no-image](/images/manufacturer_photos/0/1/129/cel_sml.jpg)
PS2701-1-F3-L-A
Manufacturer Part Number
PS2701-1-F3-L-A
Description
OPTOISOLATOR 1CH TRANS OUT 4-SOP
Manufacturer
CEL
Series
NEPOCr
Datasheet
1.PS2701-1-F3-A.pdf
(13 pages)
Specifications of PS2701-1-F3-L-A
Number Of Channels
1
Input Type
DC
Voltage - Isolation
3750Vrms
Current Transfer Ratio (min)
100% @ 5mA
Current Transfer Ratio (max)
300% @ 5mA
Voltage - Output
40V
Current - Output / Channel
80mA
Current - Dc Forward (if)
50mA
Vce Saturation (max)
300mV
Output Type
Transistor
Mounting Type
Surface Mount
Package / Case
4-SMD
Forward Current
5 mA
Maximum Input Diode Current
5 mA
Maximum Reverse Diode Voltage
5 V
Output Device
Phototransistor
Configuration
1 Channel
Maximum Collector Emitter Voltage
40 V
Maximum Collector Emitter Saturation Voltage
0.3 V
Isolation Voltage
3750 Vrms
Current Transfer Ratio
100 % to 300 %
Maximum Forward Diode Voltage
1.4 V
Maximum Operating Temperature
+ 100 C
Minimum Operating Temperature
- 55 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Lead Free Status / RoHS Status
Lead free / RoHS Compliant, Lead free / RoHS Compliant
(4) Cautions
2. Cautions regarding noise
3. Measurement conditions of current transfer ratios (CTR), which differ according to
photocoupler
USAGE CAUTIONS
10
1. Protect against static electricity when handling.
2. Avoid storage at a high temperature and high humidity.
• Fluxes
collector-emitters at startup, the output transistor may enter the on state, even if the voltage is within the absolute
maximum ratings.
to product.
standard curves due to CTR value variations or the like. This tendency may sometimes be obvious, especially
below I
like into consideration before use.
Be aware that when voltage is applied suddenly between the photocoupler’s input and output or between
Check the setting values before use, since the forward current conditions at CTR measurement differ according
When using products other than at the specified forward current, the characteristics curves may differ from the
Therefore, check the characteristics under the actual operating conditions and thoroughly take variations or the
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
F
= 1 mA.
Data Sheet PN10240EJ03V0DS
PS2701-1