PS2701A-1-M-A CEL, PS2701A-1-M-A Datasheet - Page 9
![no-image](/images/manufacturer_photos/0/1/129/cel_sml.jpg)
PS2701A-1-M-A
Manufacturer Part Number
PS2701A-1-M-A
Description
OPTOISOLATOR 1CH TRANS OUT 4-SOP
Manufacturer
CEL
Series
NEPOCr
Specifications of PS2701A-1-M-A
Number Of Channels
1
Input Type
DC
Voltage - Isolation
3750Vrms
Current Transfer Ratio (min)
50% @ 5mA
Current Transfer Ratio (max)
150% @ 5mA
Voltage - Output
70V
Current - Output / Channel
30mA
Current - Dc Forward (if)
30mA
Vce Saturation (max)
300mV
Output Type
Transistor
Mounting Type
Surface Mount
Package / Case
4-SMD
Isolation Voltage
3750 Vrms
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
(2) Wave soldering
(3) Soldering by soldering iron
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220 C
• Time to preheat temperature from 120 to 180 C
• Number of reflows
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100 C.
260 C or below (molten solder temperature)
10 seconds or less
120 C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Data Sheet PN10396EJ05V0DS
350 C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
260 C or below (package surface temperature)
10 seconds or less
60 seconds or less
120 30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
PS2701A-1
9