PS8602 CEL, PS8602 Datasheet - Page 11

• Manufacturer Part Number: PS8602
• Description: OPTOCOUPL ANALOG HS HI CMR OU
• Manufacturer: CEL
• Series: NEPOCr

Specifications of PS8602

• Number Of Channels: 1
• Input Type: DC
• Voltage - Isolation: 5000Vrms
• Current Transfer Ratio (min): 15% @ 16mA
• Voltage - Output: 35V
• Current - Output / Channel: 8mA
• Current - Dc Forward (if): 25mA
• Output Type: Transistor with Vcc
• Mounting Type: Through Hole
• Package / Case: 8-DIP
• Output Device: Integrated Photo IC
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Vce Saturation (max): -
• Current Transfer Ratio (max): -
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant, Lead free / RoHS Compliant

NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
(2) Wave soldering
(3) Cautions
2. Cautions regarding noise
collector-emitters at startup, the output side may enter the on state, even if the voltage is within the absolute
maximum ratings.
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Fluxes
Be aware that when voltage is applied suddenly between the photocoupler’s input and output or between
Avoid removing the residual flux with freon-based and chlorine-based cleaning solvent.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120˚C
(preheating)
120±30 s
Data Sheet PN10263EJ01V0DS
180˚C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
260˚C MAX.
220˚C
PS8602,PS8602L
11