PS2505-2-A CEL, PS2505-2-A Datasheet - Page 10
![PHOTOCOUPLER 2CH TRANS 8-DIP](/photos/7/67/76745/51-8-dip_sml.jpg)
PS2505-2-A
Manufacturer Part Number
PS2505-2-A
Description
PHOTOCOUPLER 2CH TRANS 8-DIP
Manufacturer
CEL
Series
NEPOCr
Datasheet
1.PS2505-1-A.pdf
(13 pages)
Specifications of PS2505-2-A
Number Of Channels
2
Input Type
AC, DC
Voltage - Isolation
5000Vrms
Current Transfer Ratio (min)
80% @ 5mA
Current Transfer Ratio (max)
600% @ 5mA
Voltage - Output
80V
Current - Output / Channel
50mA
Current - Dc Forward (if)
±80mA
Vce Saturation (max)
300mV
Output Type
Transistor
Mounting Type
Through Hole
Package / Case
8-DIP
Maximum Fall Time
5 us
Maximum Input Diode Current
80 mA
Maximum Rise Time
3 us
Maximum Collector Emitter Voltage
80 V
Maximum Collector Emitter Saturation Voltage
0.3 V
Isolation Voltage
5000 Vrms
Current Transfer Ratio
600 %
Maximum Forward Diode Voltage
1.4 V
Maximum Collector Current
50 mA
Maximum Power Dissipation
120 mW
Maximum Operating Temperature
+ 100 C
Minimum Operating Temperature
- 55 C
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
PS2505-2A
NOTES ON HANDLING
1. Recommended soldering conditions
(1) Infrared reflow soldering
(2) Wave soldering
(3) Soldering by soldering iron
10
• Peak reflow temperature
• Time of peak reflow temperature
• Time of temperature higher than 220°C
• Time to preheat temperature from 120 to 180°C
• Number of reflows
• Flux
• Temperature
• Time
• Preheating conditions
• Number of times
• Flux
• Peak temperature (lead part temperature)
• Time (each pins)
• Flux
(a) Soldering of leads should be made at the point 1.5 to 2.0 mm from the root of the lead.
(b) Please be sure that the temperature of the package would not be heated over 100°C.
260°C or below (molten solder temperature)
10 seconds or less
120°C or below (package surface temperature)
One (Allowed to be dipped in solder including plastic mold portion.)
Rosin flux containing small amount of chlorine (The flux with a maximum chlorine
content of 0.2 Wt% is recommended.)
Recommended Temperature Profile of Infrared Reflow
120°C
(preheating)
120±30 s
Data Sheet PN10228EJ03V0DS
350°C or below
3 seconds or less
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
180°C
260°C or below (package surface temperature)
10 seconds or less
60 seconds or less
120±30 s
Three
Rosin flux containing small amount of chlorine (The flux with a
maximum chlorine content of 0.2 Wt% is recommended.)
Time (s)
(heating)
to 60 s
to 10 s
PS2505-1,-4,PS2505L-1,-4
260°C MAX.
220°C