SMC01GCFC6E NUMONYX, SMC01GCFC6E Datasheet - Page 20
![no-image](/images/manufacturer_photos/0/4/484/numonyx_sml.jpg)
SMC01GCFC6E
Manufacturer Part Number
SMC01GCFC6E
Description
COMPACT FLASH MEM CARD 1GB F3
Manufacturer
NUMONYX
Datasheet
1.SMC064CFA6E.pdf
(29 pages)
Specifications of SMC01GCFC6E
Memory Size
1GB
Memory Type
CompactFLASH
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Card configuration
6
7
8
9
10
20/29
Card configuration
Refer to paragraph 4.4 of CF specification 3.0.
Host configuration requirements
The CompactFlash advanced timing modes include PCMCIA-style I/O modes that are faster
than the original 250 ns cycle time (see
Before configuring the card interface for the I/O mode, the host must ensure that all the
cards connected to a given electrical interface support I/O transfers faster than 250 ns.
These modes must be used in the conditions described in
requirements for CompactFlash advanced timing
connected to one card only. Consequently, the host must not configure a card to operate in
an CompactFlash advanced timing mode if two cards are sharing the same I/O lines in
master/slave operation, or if it is connected to the card through a cable which length
exceeds 0.15 m.
The load presented to the host by cards supporting Ultra DMA is more controlled than that
presented by other CompactFlash cards. Therefore, the use of a card that does not support
Ultra DMA in a master/slave arrangement with a Ultra DMA card can affect the critical timing
of the Ultra DMA transfers. The host shall not configure a card into Ultra DMA mode when a
card not supporting Ultra DMA is also present on the same interface.
When the use of two cards on an interface is otherwise permitted, the host may use any
mode that is supported by both cards, but to achieve maximum performance it should use its
highest performance mode that is also supported by both cards.
Software interface
Refer to section 6.1 of CF specification version 3.0.
CF-ATA registers
Refer to section 6.1.5 of CF specification version 3.0.
CF-ATA command description
Refer to section 6.2 of CF specification version 3.0.
Section 1:
mode. In particular, the host can be
Description).
Section 4.4: Additional
SMC01GCF, SMC08GCF