NHD-0216K3Z-NSW-BBW Newhaven Display, NHD-0216K3Z-NSW-BBW Datasheet - Page 6

• Manufacturer Part Number: NHD-0216K3Z-NSW-BBW
• Description: LCD MOD SERIAL 2X16 BLU TRANSM
• Manufacturer: Newhaven Display

Specifications of NHD-0216K3Z-NSW-BBW

• Display Type: STN - Super-Twisted Nematic
• Display Mode: Transmissive
• Number Of Digits/alpha: 32
• Outline L X W X H: 80.00mm x 36.00mm x 13.50mm
• Viewing Area: 64.50mm L x 16.40mm W
• Backlight: LED - White
• Display Format: 16 x 2
• Character Size: 5.23mm H x 3.00mm W
• Character Format: 5 x 8 Dots
• Voltage - Supply: 4.7 V ~ 5.5 V
• Dot Size: 0.56mm W x 0.61mm H
• Interface: Serial
• Operating Temperature: -20°C ~ 70°C
• Character Count X Line: 16 x 2
• Module Size (w X H X T): 80 mm x 26.3 mm x 13.5 mm
• Fluid Type: STN Negative
• Background Color: Blue
• Voltage Rating: 5 V
• Operating Temperature Range: - 20 C to + 70 C
• Backlight Type: LED White
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant, Lead free / RoHS Compliant

Communication Information
This display uses a built‐in PIC 16F690 for serial communication.
I2C protocol:
To enter the I2C mode, place a jumper on R1.
SDA and SDK have pull‐up resistors (10K Ohm) on R7 and R8.
The default I2C address is 80 (50 hex). The I2C address can be changed to any 8‐bit value by command function, with
the exception that the LSB (least significant bit) must always be ‘0’. Once the I2C address has been changed, it will be
saved in the system memory, and it will revert back to the default address if either RS232 or SPI protocol is selected.
The I2C interface is capable of receiving data at up to 100KHz‐clock rate.
SPI protocol:
To enter the SPI mode, place a jumper on R2.
SPI mode has a normally high level idle clock. When Slave Select is LOW, data is sampled on the rising edge of the
Clock.
The SPI interface is capable of receiving data at up to 100KHz‐clock rate.
RS232 protocol:
To enter the RS232 mode, both R1 and R2 should be open.
The RS232 signal must be 5V TTL compatible. Communication format is 8‐bit data, 1 Stop bit, no parity, no hand‐
shaking. Default BAUD rate is 9600, and is changeable with a command function. Once the BAUD rate has been
changed, it will be saved in the system memory, and it will revert back to the default address if either I2C or SPI
protocol is selected.
ASCII TEXT
To display normal text, just enter its ASCII number. A number from 0x00 to 0x07 displays the user
defined custom character, 0x20 to 0x7F displays the standard set of characters, 0xA0 to 0xFD display
characters and symbols that are factory‐masked on the SPLC780D controller. 0xFE is reserved.
[6]