GLK12232-25-SM-WB Matrix Orbital, GLK12232-25-SM-WB Datasheet - Page 18

• Manufacturer Part Number: GLK12232-25-SM-WB
• Description: LCD GRAPHIC DISPL 122X32 BLU/WHT
• Manufacturer: Matrix Orbital

Specifications of GLK12232-25-SM-WB

• Display Type: LCD - Monochrome
• Display Mode: Transmissive
• Viewing Area: 60.20mm L x 18.00mm W
• Dot Size: 0.40mm W x 0.40mm H
• Dot Pitch: 0.44mm x 0.44mm
• Dot Pixels: 122 x 32
• Interface: I²C, RS232, TTL
• Pixel Density: 32 x 122
• Module Size (w X H X T): 86 mm x 35 mm x 14.4 mm
• Viewing Area (w X H): 60.2 mm x 18 mm
• Backlighting: Blue
• Background Color: Blue
• Operating Temperature Range: - 20 C to + 70 C
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Backlight: -
• Lead Free Status / Rohs Status: Details
• Other names: 635-1001

example, shades of grey are not supported.
5.2 Graphics Commands
toward the right) and Y values go from 0 to 63 (increasing toward the bottom).
5.2.1 Set Drawing Colour (254 99 [color])
color passed as a parameter. The parameter [color] is the value of the color where white 0 Hex, and black is
255 Hex.
5.2.2 Draw Line (254 108 [x1][y1][x2][y2])
be drawn from any part of the display to any other part, but may be important to note that the line may
interpolate differently right to left, or left to right. This means that a line drawn in white from right to left
may not fully erase the same line drawn in black from left to right.
5.2.3 Continue Line (254 101 [x][y])
command uses the global drawing color so the “Set drawing color” command should be used before the first
line segment if required.
5.2.4 Put Pixel (254 112 [x][y])
requests fast enough to keep up with a steady stream at 115 kbaud, so flow control is not required.
5.2.5 Draw Outline Rectangle (254 114 [color][x1][y1][x2][y2])
corner is specified by (x1,y1) and the bottom right corner by (x2,y2).
Matrix Orbital
Each pixel in a bitmap is described by a single bit, and may only have the values ON or OFF. For
In this section commands are identified by their names and decimal values.
The coordinate origin (0,0) is at the top left corner of the display. X values go from 0 to 239 (increasing
This command sets the drawing color for subsequent graphic commands that do not have the drawing
This command will draw a line from (x1,y1) to (x2,y2) using the current drawing color. Lines may
This command will draw line with the current drawing color from the last line end (x2,y2) to (x,y). This
This command will draw a pixel at (x,y) using the current drawing color. The unit processes these
This command draws a rectangular box in the specified color (0 = white, non-zero = black). The top left
NOTE All non-zero values will display as black.
GLK12232-25-SM
14