T-51381L064J-FW-P-AD Optrex America Inc, T-51381L064J-FW-P-AD Datasheet - Page 18
![no-image](/images/no-image-200.jpg)
T-51381L064J-FW-P-AD
Manufacturer Part Number
T-51381L064J-FW-P-AD
Description
LCD 6.4" TFT MOD W/NTSC/PAL DEC
Manufacturer
Optrex America Inc
Datasheet
1.T-51381L064J-FW-P-AD.pdf
(20 pages)
Specifications of T-51381L064J-FW-P-AD
Mfg Application Notes
T-51381L064J-FW-P-AD Appl Note
Display Type
TFT- Thin Film Transistor
Display Mode
*
Viewing Area
130.10mm L x 97.30mm W
Dot Pitch
0.42mm x 0.14mm
Dot Pixels
960 x 234
Interface
-
Backlight
-
Dot Size
-
Other names
73-1200
9. Handling Cautions
9-1) Mounting of module
9-2) Precautions in mounting
9-3) Adjusting module
9-4) Others
a) Please power off the module when you connect the input/output connector.
b) Please connect the ground pattern of the inverter circuit surely. If the connection
a) When metal part of the TFT-LCD module (shielding lid and rear case) is soiled,
b) Wipe off water drops or finger grease immediately. Long contact with water may
c) TFT-LCD module uses glass which breaks or cracks easily if dropped or
d) Since CMOS LSI is used in the module. So take care of static electricity and
a) Adjusting volumes on the rear face of the module have been set optimally before
b) Therefore, do not change any adjusted values. If adjusted values are changed,
a) Do not expose the module to direct sunlight or intensive ultraviolet rays for many
b) Store the module at a room temperature place.
c) The voltage of beginning electric discharge may over the normal voltage
d) If LCD panel breaks, it is possibly that the liquid crystal escapes from the panel.
e) Observe all other precautionary requirements in handling general electronic
f) Please adjust the voltage of common electrode as material of attachment by 1
T-51381L064J-FW-P-AD
c) Polarizer which is made of soft material and susceptible to flaw must be
d) Protective film (Laminator) is applied on surface to protect it against scratches
1.The noise from the backlight unit will increase.
2.The output from inverter circuit will be unstable.
3.In some cases a part of module will heat.
wipe it with soft dry cloth.
cause discoloration or spots.
bumped on hard surface. Please handle with care.
earth yourself when handling.
shipment.
the specifications described may not be satisfied.
hours.
because of leakage current from approach conductor by to draw lump read lead
line around.
Avoid putting it into eyes or mouth. When liquid crystal sticks on hands, clothes
or feet. Wash it out immediately with soap.
components.
module.
handled carefully.
and dirts. It is recommended to peel off the laminator before use and taking
care of static electricity.
is not perfect, some following problems may happen possibly.
OPTREX CORPORATION
Page-18/20