T-51756D121J-FW-A-AB Optrex America Inc, T-51756D121J-FW-A-AB Datasheet - Page 20

• Manufacturer Part Number: T-51756D121J-FW-A-AB
• Description: LCD 12.1" TFT MOD 1024X768 XGA
• Manufacturer: Optrex America Inc

Specifications of T-51756D121J-FW-A-AB

• Display Type: TFT- Thin Film Transistor
• Display Mode: Reflective
• Viewing Area: 245.80mm L x 184.30mm W
• Backlight: LED - White
• Dot Pitch: 0.24mm x 0.24mm
• Dot Pixels: 1024 x 768 (XGA)
• Interface: LVDS
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant
• Dot Size: -

(2) OPERATING PRECAUTIONS
(3) PRECAUTIONS WITH ELECTROSTATICS
(4) STORAGE PRECAUTIONS
i. Please handle metal frame carefully because edge of metal frame is very sharp.
j. Please pay attention to handling lead wire of backlight so that it is not tugged in connecting
k. Please connect the metal frame of LCD module to GND in order to minimize the effect of
l. Be sure to connect the cables and the connecters correctly.
a. Please be sure to turn off the power supply before connecting and disconnecting signal input
b. Please do not change variable resistance settings in LCD module. They are adjusted to the
c. LCD backlight takes longer time to become stable of radiation characteristics in low
d. The interface signal speed is very high. Please pay attention to transmission line design and
e. A condensation might happen on the surface and inside of LCD module in case of sudden
f. Please pay attention not to display the same pattern for very long time. Image might stick on
g. Please obey the same safe instructions as ones being prepared for ordinary electronic products.
a. This LCD module use CMOS-IC on circuit board and TFT-LCD panel, and so it is easy to be
b. Please remove protection film very slowly from the surface of LCD module to prevent from
a. Please do not leave the LCDs in the environment of high humidity and high temperature such
b. Please do not leave the LCDs in the environment of low temperature; below –20°C.
OPTREX Confidential
with inverter.
external noise and EMI.
cable.
most suitable value. If they are changed, it might happen LCD does not satisfy the
characteristics specification.
temperature than in room temperature.
other high speed signal precautions to satisfy signal specification.
change of ambient temperature.
LCD. Even if image sticking happens, it may disappear as the operation time proceeds.
affected by electrostatics. Please be careful with electrostatics by the way of your body
connecting to the ground and so on.
electrostatics occurrence.
as 60°C90%RH.
(20/21)
T-51756D121J-FW-A-AB