LTW-420D7 Lite-On Electronics, LTW-420D7 Datasheet
LTW-420D7
Specifications of LTW-420D7
Related parts for LTW-420D7
LTW-420D7 Summary of contents
Page 1
... All dimensions are in millimeters (inches). 2. Tolerance is ± 0.25mm(.010") unless otherwise noted. 3. Protruded resin under flange is 1.0mm(.04") max. 4. Lead spacing is measured where the leads emerge from the package. 5. Specifications are subject to change without notice. Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION Lens Color ...
Page 2
... Absolute Maximum Ratings at T PARAMETER Power Dissipation Peak Forward Current (1/10 Duty Cycle, 0.1ms Pulse Width) DC Forward Current Reverse Voltage Operating Temperature Range Storage Temperature Range Lead Soldering Temperature [1.6mm(.063") From Body] Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION =25 ℃ a MAXIMUM RATING 120 100 30 5 -25 ℃ ...
Page 3
... It is necessary to cut the lead frame at normal temperature. 7. Caution in ESD: Static Electricity and surge damages the LED recommend to use a wrist band or anti-electrostatic glove when handling the LED. All devices, equipment and machinery must be properly grounded. Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION SYMBOL MIN ...
Page 4
... Typical Electrical / Optical Characteristics Curves (25 ℃ Ambient Temperature Unless Otherwise Noted) Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION Page : ...
Page 5
... Total 10,000 pcs per inner carton 8 Inner cartons per outer carton Total 80,000 pcs per outer carton Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION Packing Spec Page : ...
Page 6
... Iv Bin Luminous Intensity Measurement allowance is 15% Hue Bin Color Coordinates Measurement allowance is ±0.01 Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION Spec. Table for Reference Luminous Intensity (mcd 20mA min. 2500 3200 4200 5500 Hue Spec. Table for Reference Chromaticity Coordinates x 0.370 0.370 y 0 ...
Page 7
... An LED is a current operated device, In order to ensure intensity uniformity on multiple LEDs connected in parallel in an application recommended that a current limiting resistor be incorporated in the drive circuit. In series with each LED as shown in Circuit A below. Circuit model A LED Part No. : LTW-420D7 LITE-ON TECHNOLOGY CORPORATION CAUTIONS Wave soldering ...
Page 8
BNS-OD-C131/A4 7. ESD (Electrostatic Discharge) Static Electricity or power surge will damage the LED. Suggestions to prevent ESD damage. ■ Use a conductive wrist band or anti-electrostatic glove when handling these LEDs. ■ All devices , equipment , and machinery ...
Page 9
... Part No. : LTW-420D7 BNS-OD-C131/A4 LITE-ON TECHNOLOGY CORPORATION Page : ...