LSM2-T/30-D12-C Murata Power Solutions Inc, LSM2-T/30-D12-C Datasheet
LSM2-T/30-D12-C
Specifications of LSM2-T/30-D12-C
811-1792-1
811-1792-1
Available stocks
Related parts for LSM2-T/30-D12-C
LSM2-T/30-D12-C Summary of contents
Page 1
... The automated surface mount assembly is fully compatible with RoHS (Reduction of Hazard- ous Substances) construction and attachment. The LSM2-T/30-D12 mounts to its host carrier board via refl ow-soldered PCB pads. The extraordinary effi ciency means low heat and freedom from expensive, bulky heat sinks. A ...
Page 2
... Q LSM2-T/30-D12 effi ciencies are shown max Amps with V OUT ➆ >3.63V, input range is 7-14V. OUT ➇ LSM2-T/30-D12R-C-CIS models use a 100KΩ resistor between the gate and source of the internal On/Off (Enable) FET controlling the PWM Current in Amps www.murata-ps.com DOSA-SMT, 30A POL DC/DC Converters REFERENCE & ...
Page 3
... The “R” pads and the standard pads 1 and 2 are in parallel. If your application uses a standard DOSA pad layout and you cannot con- nect to these ground pads, order model LSM2-T/30-D12-C without the “R” designator. Please observe the lower Derating curves for standard, “non-R” ...
Page 4
See Note 1 See Ordering Guide Not isolated. Input and output Commons are internally connected. 5.6 Volts 5 Volts None (Note pk-pk Capacitive None, install external fuse. 35 Amps, fast blow Full Load Conditions See Ordering Guide ...
Page 5
... Rtrim (Ohms) ο C) mounted close to The LSM2 Series may also be trimmed using an external low-noise voltage applied between the Trim input and Output Common. Be aware that the inter- nal “load” impedance looking into Trim pin is below 1000 Ohms and includes factors from the output voltage. Therefore, use a low impedance source resistance in your external voltage reference. The fi ...
Page 6
Extra ground pads installed. 31.00 30.00 300 LFM 29.00 400 LFM 28.00 500 LFM 27.00 26.00 25.00 24.00 23.00 22.00 21.00 20.00 Natural Convection 19.00 ...
Page 7
...
Page 8
...
Page 9
...
Page 10
...
Page 11
...