FNP1500-12G POWER ONE, FNP1500-12G Datasheet

Page 1

... Status information is provided with front panel LEDs, logic signals, and via an I can enable the power supply, set high fan speed, adjust the output voltage, and set the output current limit. The FNP1500/1800's meet international safety standards and display the CE-Mark for the European Low Voltage Directive (LVD). ...

Page 2

... Non-Operating Conditions/Description Operating Non-Operating Operating Storage 0 ° °C (after 15 min warm-up) IEC/EN 60068-2-27 IEC/EN 60068-2-6 2-8 Hz 8-200 Hz 200-500 Hz 10-2000 Hz Calculated per Bellcore (SR-332, Issue 1 ° °C (FNP1500-12G) Demonstrated Page FNP1500/1800 Front-Ends Output 2 Rated power I o2 max W ADC 1 1512 1 1212 1 1512 ...

Page 3

... Turn-off input voltage Inrush current limitation Hold-up time Power factor Efficiency Max input current Input connector 1 87% for FNP1500-12 MCD10074 Rev. 1.2, 15-Apr-10 & FNR-3 Power Shelves Data Sheet Conditions/description UL60950, (UL) CSA 60950 (cUL), EN 60950(TÜV), CE Mark for LVD Input to case Input to output ...

Page 4

... FNP1800-12G regulation output 1 (droop characteristic) Static load regulation output 2 (droop characteristic) Dynamic FNP1500-12G load & FNP1800-12G regulation FNP1500-12G & FNP1800-12G Current FNP1500-12G Share FNP1800-12G Start-up time Output voltage ripple and noise (Filter 10nF/10µF) Remote sense 1 FNP1800-12G max is 12V. MCD10074 Rev. 1.2, 15-Apr-10 & ...

Page 5

... Time required for output within regulation after initial application of AC-input (V i nom after removal of inhibit (V i nom , MHz bandwidth V i nom o nom Total compensation for cable losses Page FNP1500/1800 Front-Ends Min Nom Max 48 12 -0.5 +0 32.2 25.4 39.2 39.2 32.2 25.4 36 ...

Page 6

... Indicates if the fans are operating or have failed. Overcurrent signal which can be used for synchronous startup of units in parallel or to recover from an overload condition. (See application note Manual found on the Power-One web site. Page FNP1500/1800 Front-Ends Min Nom Max Unit 25A, fast blow ...

Page 7

... Open or connected to synch startup circuit, referenced the output connector o1 Open or connected to synch startup circuit, referenced the output connector o1 Main output + pins Main output – pins Main output + pins Main output – pins Page FNP1500/1800 Front-Ends Low level V max High level I max < 0 Pull < 0 Pull ...

Page 8

... Mechanical Data (FNP1500/1800 12V Models) Mechanical Data ( FNP1500/1800 12V Model Output Connector Descriptions Rear View Female Connector: FCI (51732-026 LF) Mates with: 90° output connector type: 180° output connector type: Locate information on availability of FCI connectors at Connector drawings available at: http://portal.fciconnect.com/portal/page/portal/FcicntPublic/DocSrchCustDraw IEC AC power cord with C19 connector VDE 16A: Interpower Components Ltd. 70009110250 IEC AC power cord with C19 connector UL MCD10074 Rev ...

Page 9

... Mechanical Data (FNP1500/1800 48V Models) Mechanical Data ( FNP1500/1800 48V Model Output Connector Descriptions Rear View Female Connector: FCI (51732-020 LF) Mates with: 90° output connector type: 180° output connector type: Locate information on availability of FCI connectors at Connector drawings available at: http://portal.fciconnect.com/portal/page/portal/FcicntPublic/DocSrchCustDraw IEC AC power cord with C19 connector VDE 16A: Interpower Components Ltd. 70009110250 IEC AC power cord with C19 connector UL MCD10074 Rev ...

Page 10

... MCD10074 Rev. 1.2, 15-Apr-10 & FNR-3 Power Shelf Data Sheet -, all V + and to leave the internal GND’s open. o2 17.7” (449.6 mm) x 1.7” (43.1 mm) x 13” (330.2 mm) Page FNP1500/1800 Front-Ends 2 C signals (T1-T5, S1, and S2) can be left 2 C-lines, monitoring signals and www.power-one.com ...

Page 11

... Output 1 plus G 5-Bit DIP switch for I H 37-pin SUB-D connector, controlling and auxiliary power (output 2) I 5-Bit DIP switch for I MCD10074 Rev. 1.2, 15-Apr-10 & FNR-3 Power Shelf Data Sheet addressing of PSU addressing of PSU addressing of PSU 3 Page FNP1500/1800 Front-Ends H I www.power-one.com ...

Page 12

... GND Ω OC-output, protected Zener diode and a 10 resistor in series, referenced to logic GND Ω compatible signal referenced to logic GND Page FNP1500/1800 Front-Ends Low level High level <0 Pull up Open Pull up Open Pull up <0 Pull up <0 ...

Page 13

... I C return. Leave open if not used. Open or connected to V sense sense- o1 sense+ Open or connected to V sense sense- o1 sense+ Open or connected to V sense sense- o1 sense+ Page FNP1500/1800 Front-Ends Low level V max High level 3.3 V logic ) www.power-one.com I max 60V 60V 60V ...

Page 14

... NOTE: The Sync-Start pins can be wired together only if the power supplies are connected with a minimal voltage drop on power ground as achieved on a backplane with massive copper bus bars. If there is a less ideal connection recommended to use an opto-coupler for each unit (IC1, D3, D2). MCD10074 Rev. 1.2, 15-Apr-10 FNP1500/1800 Front-Ends & FNR-3 Power Shelf Data Sheet Type V ...

Page 15

... Mechanical Data (FNR-3-12G and FNR-3-48G Power Shelves) MCD10074 Rev. 1.2, 15-Apr-10 FNP1500/1800 Front-Ends & FNR-3 Power Shelf Data Sheet Page www.power-one.com ...

Page 16

... Center Angular Brackets are set in the middle for shelf mounting: Center Angular Bracket sets can be ordered: Power-One part no.: HZZ01222 Note: Each Center Angular Bracket set contains 2 brackets and 8 screws. MCD10074 Rev. 1.2, 15-Apr-10 FNP1500/1800 Front-Ends & FNR-3 Power Shelf Data Sheet Page www.power-one.com ...

Page 17

... I C-to-USB interface (P/N HZZ02002G range of parameters that can be programmed to the FNP1500/1800 front-ends. This manual is available by searching on "FNP1500" at www.power-one.com. NUCLEAR AND MEDICAL APPLICATIONS - Power-One products are not designed, intended for use in, or authorized for use as critical components in life support systems, equipment used in hazardous environments, or nuclear control systems without the express written consent of the respective divisional president of Power-One, Inc ...