EQ-IOCON-3 Equinox Technologies, EQ-IOCON-3 Datasheet - Page 43
![MOD PPM3 CONN-3 I/O ATMEGA JTAG](/photos/8/97/89790/eq-iocon-3_sml.jpg)
EQ-IOCON-3
Manufacturer Part Number
EQ-IOCON-3
Description
MOD PPM3 CONN-3 I/O ATMEGA JTAG
Manufacturer
Equinox Technologies
Datasheet
1.EQ-IOCON-3.pdf
(46 pages)
Specifications of EQ-IOCON-3
Accessory Type
I/O Connector Module
For Use With/related Products
PPM3-MK2
Other names
483-1005
EQ-IOCON-3
EQ-IOCON-3
9.0 EQ-CALCON Module
9.1 Overview
The EQ-CALCON Module is a special plug-in I/O Connector Module for the PPM3-MK2 programmer
which is used to facilitate very accurate calibration of the Internal Oscillator of an Atmel ATmega or
ATtiny AVR microcontroller. The module features an on-board high accuracy 32kHz Oscillator
Module which can be connected to the target AVR microcontroller MOSI pin during the Oscillator
Calibration Procedure as described in the Atmel Application Note 'AVR053: Calibration of the Internal
Oscillator'.
The EQ-CALCON Module is simply an I/O Connection Module with an on-board 32kHz oscillator. The
target microcontroller SPI or JTAG signal lines connect to the module headers or clip-in connectors.
The 32kHz oscillator is then switched onto the target device MOSI pin under control of the
Programming Project running in the programmer. The EQ-CALCON Module must be used in
conjunction with a PPM3-MK2 programmer in order to operate.
9.2 Features
9.3 Supported Device Families
This CALCON supports ISP programming of the following device families:
Low / High Voltage SPI programming algorithm:
40
•
•
•
•
•
•
•
•
•
•
•
•
•
•
•
Plugs into I/O Con connector socket on PPM3-MK2 programmer
Generates an accurate 32kHz square wave signal under control of the programmer
Support calibration of the on-chip oscillator of Atmel AVR microcontrollers
Features Atmel 6-way SPI, Atmel JTAG 10-way and Equinox 10-way SPI ISP headers
Features clip-in ‘Fast Connect’ connectors for east connection to wires from Test Probes in a
Test Fixture environment
Atmel AT89S (LV SPI)
Atmel AT90S (LV SPI)
Atmel ATtiny (LV SPI)
Atmel ATtiny (High Voltage)
Atmel ATmega (LV SPI)
Atmel 90CAN (LV SPI)
Atmel 90USB (LV SPI)
Atmel 90PWM (LV SPI)
Atmel ATmega PICO (LV SPI)
Zensys ZW (LV SPI)
I/O Connector Modules (IO-CON) for the PPM3 Programming Module – V1.04 – 1
st
April 2008