STEVAL-PCC006V1 STMicroelectronics, STEVAL-PCC006V1 Datasheet - Page 4
![BOARD EVAL FOR EVAL-STR910](/photos/8/99/89980/steval-pcc006v1_sml.jpg)
STEVAL-PCC006V1
Manufacturer Part Number
STEVAL-PCC006V1
Description
BOARD EVAL FOR EVAL-STR910
Manufacturer
STMicroelectronics
Specifications of STEVAL-PCC006V1
Accessory Type
Bridge
For Use With/related Products
EVAL-STR910
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Other names
497-8268
Getting started
1
1.1
1.2
1.3
4/22
Getting started
Package
The HDD bridge extension board for the EVAL-STR910 includes the following items:
1.
2.
3.
No PC software nor drivers are required in order to use the Microsoft
Setting up the board
The following hardware is required for the correct usage of the system.
●
●
●
●
The HDD bridge extension board for the STR9-EVAL should be set up as follows:
1.
2.
3.
4.
5.
6.
7.
Hardware layout configuration
The hardware layout in
extension board. For the hardware layout of the EVAL-STR910 board refer to user manual
UM0174 "EVAL-STR910 demonstration board".
Hardware content:
–
Documentation:
–
Firmware:
–
EVAL-STR910 demonstration board
Extension board interface between the EVAL-STR910 and the hard disk
ATX-SMPS to power on the hard disk
40-pin hard disk cable.
Before connecting the extension board to the EVAL-STR910 remove resistors R51,
R81, R82, R83, R84, and R90. Refer to
provides a utility to connect a daughterboard through the CN5 and CN6 connectors by
disconnecting the resistors from the functional blocks.
Connect the jumper between pin 1 and 2 of JP9 of the EVAL-STR910 board. The
1.5 kΩ
Fix the extension board on the EVAL-STR910 board. Please make sure that the STR9
CN5 connector is aligned with the extension board STR9_CN5 connector. Refer to
Figure
Connect the 40-pin hard disk cable between the hard disk and extension board.
To power on the hard disk as well as the board, set the jumpers according to the
available source of power, refer to
Insert the USB cable in the CN3 connector of the EVAL-STR910 board and the PC.
Now the PC shows the hard disk as a removable drive, and the user can access the
hard disk as a normal storage unit.
Extension board interface between the EVAL-STR910 and the hard disk
User manual (this document)
Hex file is available for the firmware
9.
resistor
pull-up is controlled by this jumper.
Figure 2
Doc ID 15036 Rev 1
shows the location of the different components on the
Section 1.4.1: Power supply on page
Figure 8
in
Appendix
A. The EVAL-STR910
®
operating system.
6.
UM0592