ST7MDT10-TEB/DVP STMicroelectronics, ST7MDT10-TEB/DVP Datasheet - Page 26
![no-image](/images/manufacturer_photos/0/6/637/stmicroelectronics_sml.jpg)
ST7MDT10-TEB/DVP
Manufacturer Part Number
ST7MDT10-TEB/DVP
Description
KIT ADAPTERS ST7
Manufacturer
STMicroelectronics
Datasheet
1.ST7MDT10-TEBDVP.pdf
(31 pages)
Specifications of ST7MDT10-TEB/DVP
Accessory Type
Target Board
For Use With/related Products
ST7MDT10-DVP3 Emulator
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
Appendix A: EMC Conformity and Safety Requirements
APPENDIX A: EMC CONFORMITY AND SAFETY REQUIREMENTS
26/31
This product respects the EMC requirements of the European guideline 89/336/
EEC under the following conditions:
•
•
•
•
•
•
•
•
•
•
Any tester, equipment, or tool used at any production step, or for any
manipulation of semiconductor devices, must have its shield connected to
ground.
All provided ferrites must be attached as described in the hardware installation
instructions of the relevant user manual(s).
The product must be placed on a conductive table top, made of steel or clean
aluminum, or covered by an antistatic surface (superficial resistivity equal to or
higher than 0.5 MΩ/cm
from protected equipment to ground isolated with a 1 MΩ resistor placed in
series). All manipulation of finished must be done at such a grounded
worktable.
The worktable must be free of all non-antistatic plastic objects.
An antistatic floor covering grounded through a conductive ground cable (with
serial resistor between 0.9 and 1.5 MΩ) should be used.
It is recommended that you wear an antistatic wrist or ankle strap, connected to
the antistatic floor covering or to the grounded equipment.
If no antistatic wrist or ankle strap is worn, before each manipulation of the
powered-on tool, you must touch the surface of the grounded worktable.
It is recommended that antistatic gloves or finger coats be worn.
It is recommended that nylon clothing be avoided while performing any
manipulation of parts.
If you are using this product under conditions where there may be blackouts or
power surges (such as during an electrical storm), it is recommended that you
isolate it by elevating it at least 10 cm above the grounded work surface using
blocks of insulating material.
2
), grounded through a ground cable (conductive cable
ST7MDT10-DVP3 Probe User Guide