DC9S08QE32 Freescale Semiconductor, DC9S08QE32 Datasheet - Page 11
DC9S08QE32
Manufacturer Part Number
DC9S08QE32
Description
DAUGHTER CARD FOR DEMO9S
Manufacturer
Freescale Semiconductor
Specifications of DC9S08QE32
Accessory Type
Daughter Card
Processor To Be Evaluated
MC9S08QE32
Data Bus Width
8 bit
Interface Type
RS-232, USB
Silicon Manufacturer
Freescale
Core Architecture
HCS08
Core Sub-architecture
HCS08
Silicon Core Number
MC9S08
Silicon Family Name
Flexis - S08QE
Rohs Compliant
Yes
For Use With/related Products
DEMO9S
Lead Free Status / RoHS Status
Lead free / RoHS Compliant
3.5
3.5.1
DEMO9S08QE32 User Manual
Hardware Setup
First-Time Connection
The DEMO9S08QE32 may be connected to a PC through a USB port.
Connection steps are listed below in typical order:
1. Install the required software, as described in the previous section.
2. Make sure the jumpers for USB_PWR, 3V for VOLT_EN, and
3. Plug the USB cable A-M connector into a free USB port of the PC.
4. Plug the USB cable B-M connector into the USB connector on the
5. The operating system will recognize P&E’s Embedded Multilink cir-
Figure 3-1: DEMOQE Logic Analyzer Application
REG_VDD for VDD_SELECT are installed.
DEMOQE Base Board.
cuitry and P&E’s USB to Serial circuitry. Depending on the operating
system, you may see the “Found New Hardware Wizard” dialog, help-
ing you to install software for “PEMicro USB Multilink (i0). On Win-
dows XP (SP2), the following dialog will appear:
http://www.pemicro.com/fixedlinks/demoQEtoolkit.html.
7