M3062PT3-RPD-E Renesas Electronics America, M3062PT3-RPD-E Datasheet - Page 50

• Manufacturer Part Number: M3062PT3-RPD-E
• Description: EMULATOR BASE UNIT FOR M16C/60
• Manufacturer: Renesas Electronics America

Specifications of M3062PT3-RPD-E

• Accessory Type: Emulation Pod
• For Use With/related Products: PC4701, M16C/60, M16C/30
• Lead Free Status / RoHS Status: Contains lead / RoHS non-compliant
• Other names: M3062PT3-RPD#E; M3062PT3-RPD#E

REJ10J0040-0600 Rev.6.00 July 01, 2006
M3062PT3-RPD-E User’s Manual
2.9.6 Installing and Removing Network Resistors for Pullup
In this product, you cannot control pullup for ports P0 to P5 by pullup control registers (pullup control register read/write are
possible).
A socket for installing the network resistor for pullup is mounted in this product. Mount the 51kΩ network resistor supplied
with this product to the port for which pullup control is required. For the mounting location, refer to Figure 2.24 below. And
for the positions of each part, refer to Figure 2.18.
Figure 2.24 Position for mounting network resistors for pullup
Note on Installing and Removing Network Resistors for Pullup:
Always shut OFF power before installing or removing network resistors for pullup. Otherwise, internal circuit
board may be damaged. Also install network resistors for pullup properly.
VCC2
P50
P51
P52
P53
P54
P55
P56
P57
VCC2
P00
P01
P02
P03
P04
P05
P06
P07
VCC2
P40
P41
P42
P43
P44
P45
P46
P47
CAUTION
VCC2
P10
P11
P12
P13
P14
P15
P16
P17
VCC2
P20
P21
P22
P23
P24
P25
P26
P27
VCC2
P30
P31
P32
P33
P34
P35
P36
P37
Page 48 of 104
2. Setup