AE-ISP-U1 Phyton Inc, AE-ISP-U1 Datasheet - Page 34

• Manufacturer Part Number: AE-ISP-U1
• Description: ADAPTER 28-DIP TO BH-10
• Manufacturer: Phyton Inc

Specifications of AE-ISP-U1

• Module/board Type: Adapter DIP28/BH-10
• For Use With/related Products: ChipProg+, ChipProg-40, ChipProg-48, ChipProg-G4, ChipProg-ISP
• For Use With: CHIPPROG-G4 - PROGRAMMER GANG 4 SOCKETCHIPPROG-40 - PROGRAMMER STANDALONE 40-DIPCHIPPROG-48 - PROGRAMMER STANDALONE 48-DIP
• Lead Free Status / RoHS Status: Lead free / RoHS Compliant

AE-ISP-U1
Table of connections of the adapter output socket to the device pins:
All power supply pins included AVdd must be powered. All ground pins included AVss must be
connected together.
* -The signal needs to be connected, if it is required.
AE-ISP-U1 connection for the Microchip PIC24 devices
Click the programmer model below to get an appropriate list of the devices supported by the
adapter:
Recommended connection:
http://www.phyton.com/downloads/adp/HTML/ae-isp-u1.html
resistors.
ISP characteristics:
1. Programmer's output capability:
2. The cable length should be less then one foot.
Adapter Output connector, BH-10 Target Device PIC18FxxJ
1.1 Vcc - 80 mA;
1.2 Vpp - 50 mA;
1.3 logical pins - 5 mA.
ChipProg+
ChipProg-40
ChipProg-48, ChipProg-G4
10
1
3
5
7
9
8
6
4
2
Vddcore*
MCLR
GND
GND
RB6
RB7
Vdd
-
-
-
Powering the target device:
There are two alternative options for powering
the targets:
1. The target gets power from the programmer
(Vdd). This is possible only if the target does
not consume too much energy. A capacity of
Page 34 of 56
8/19/2010